burnt hit with dual super nanos... a nightmare

Status
Not open for further replies.

benearl1

Senior Member
ECF Veteran
Nov 30, 2013
107
26
new jersey
Anyone else run dual super nano coils in their rda? Ive been running a .3 ohm dual super nano setup and I can get about 4-5 monster drags before redripping. I use like 7 drops. Unlike a regular microcoil when one can tell when the cottons starting to dry, with dual super nanos that burnt hit strikes faster than lightning! Not only that, its like 30 times worse with these coils.

One second im taking a full flavored full bodied delicious warm hit, then in that same drag, a nightmare of burnt kanthol and cotton scortching your throat! Its so unbearable!!

Sometimes when my friends or dad try my vape ill see a red glow in the airholes.. by then its too late to tell them to stop!

Still, I run this build for the love of the vape experience of the first few drags.

This isnt a complaint or plee for help I just wanted to share my story, and to read your stories as well.
 

mvroman

Super Member
ECF Veteran
Verified Member
Aug 6, 2013
416
458
Texas
I also stopped using the cotton clouds for this reason. Its a tricky balance of where to float the coil on the cloud. Ive just been sticking with a standard nano w twisted 28g. works very well. I do change it up everytime tho so i may make my way back to cotton clouds eventually

The way I have been doing clouds is soaking them and then firing with the cap off. If I see any glowing I fluff up the cloud just a bit near the glowing part and try again until it doesn't glow anymore. Normally after this adjustment it is good to go for me for awhile, sometimes after dripping it for awhile it needs to be refluffed or replaced completely.

Sent from my SAMSUNG-SGH-I337 using Tapatalk
 
Status
Not open for further replies.

Users who are viewing this thread