Buzz Pro Add On Improvement thought

[newq]

I got my new buzz pro just a short week and a half ago and had a thought. At time when I Drop on my M1a1 that i got with the buzz or a smoktech tank that I had from previous purchased and I am sliding the tank down the carto (Boge 3 ohmXL's)
Sometimes I get a bit carried away and slide them down a bit too far over the 510 connection.

Not that this is make or break world here just a convenience...

Would it be possible to revise the 510 to have a bit more of a flanged lip or even better a trim spacer with a o ring inside to slide over the 510 connector? Drip well could still be maintained by drilling or slotting the internal areas of the bushing. This would give a nice platform to prevent tanks from being over-inserted onto the device. Not terribly important but I bet i would also not be the only one standing in line for one.

 

[5cardstud]

On mine I have a thick o ring I put on the carto first that keeps it in place until it dries into position.

 

[sadtranz]

Why not just find a thin washer fit between adaptor and atty

 

[newq]

Because I didn't hesitate to buy a buzz pro, so if it were available why not? I think my buzz is beautiful why muck it up if I can enhance it?

 

[Northernshrink]

Why not just use flanged carto's

 

[5cardstud]

I don't have those issues because I use these.

 

[kempo63]

Another advantage of the fusions....that little flange, kind of "keeps yer pants from falling down"

 

[Bovinia]

Before tanks, I used to use colored carto bands to identify different flavors in my cartos. They work great if you have a tank that wants to slip a little, just pop one on the very bottom of your carto. Colored Carto Bands

 

[BuzzKill]

I got my new buzz pro just a short week and a half ago and had a thought. At time when I Drop on my M1a1 that i got with the buzz or a smoktech tank that I had from previous purchased and I am sliding the tank down the carto (Boge 3 ohmXL's)
Sometimes I get a bit carried away and slide them down a bit too far over the 510 connection.

Not that this is make or break world here just a convenience...

Would it be possible to revise the 510 to have a bit more of a flanged lip or even better a trim spacer with a o ring inside to slide over the 510 connector? Drip well could still be maintained by drilling or slotting the internal areas of the bushing. This would give a nice platform to prevent tanks from being over-inserted onto the device. Not terribly important but I bet i would also not be the only one standing in line for one.

We put the screw on the M1A1 just for this , the problem is that any flange can reduce air flow and that can cause a whole new set of problems

 

[MusicBox]

I cut down a stainless steel dripshield to fit over the 510 connection on the BP it holds the tank up, improves the aesthetics and already has holes in it for airflow.
You can see it on my BP (pictured)

 

[Bovinia]

Great idea MB!

 

[FranC]

Very clever indeed.