By Leo : Attys, mods, Drip-tips, tanks [CLOSED}

[Zbeast08]

As for Motley Crüe....love their music. I loved listening to the 80s rock. Another favorite is def leppard. They've softened over the years.
I'm a big fan of country music. I've listened to the country singer remake some of the Crüe songs. Some are actually very good. Others? Well, they should have left them on the editing table.

The Crüe put on one hell of a show and performance and the Nashville stars are doing a great job on a few of their hits, just different for me! I would have to say that this show had less girls on stage than the previous 10 times I've seen them and actually "behaved" on stage. For those that may have seen the Crüe know what I'm talking about with some of the sexual stunts these girls do in the background!!
I saw def and kiss a couple months ago and it was great too!! Love me some Foolin, and Rocket!!


Sent from my iPad using Tapatalk

 

[pmuniz10920]

I thought I had ordered an str10 beck...

 

[jhelliwell]

Hey guys. Any tips on how to resolve my issue? My Sophia's juice control gets jammed closed sometimes. I can't open it via the drip tip. and I have to pop the tank up and manually loosen it, before poping the tank back down and then opening the juice flow normally. I don't over-tighten the juice flow either. Maybe I need to check the threads or something

 

[Billie-cig]

Hey guys. Any tips on how to resolve my issue? My Sophia's juice control gets jammed closed sometimes. I can't open it via the drip tip. and I have to pop the tank up and manually loosen it, before poping the tank back down and then opening the juice flow normally. I don't over-tighten the juice flow either. Maybe I need to check the threads or somethem again

You can bend the threaded wings of the base inwards. You must be careful to do it with caution, because if you bend it more than it needs, it will start to wobble.
If that happens you can open them again of course. the SS won't break. If you still can't do it, I will send you another base

 

[jhelliwell]

You can bend the threaded wings of the base inwards. You must be careful to do it with caution, because if you bend it more than it needs, it will start to wobble.
If that happens you can open them again of course. the SS won't break. If you still can't do it, I will send you another base

Many thanks, great tip, I will give it a go.

As an aside, I just took my new Sophia on a boating holiday, hoping it would be low maintenance and leak-free. I am happy to report it performed admirably, no leaks, and a great vape every time!

 

[Billie-cig]

Many thanks, great tip, I will give it a go.

As an aside, I just took my new Sophia on a boating holiday, hoping it would be low maintenance and leak-free. I am happy to report it performed admirably, no leaks, and a great vape every time!

But keep in mind that since it has threads, it will always get tightened up if you close it with more force.

 

[StrikeIII]

Hey Billie, haven't been around much but wanted to check in to see what the status of the new dripper?

Sent from my LG G3 using Tapatalk Pro

 

[FlyD]

Someone said dripper?

 

[thewomenfolk]

Hey the womenfolk. Can I ask where you got the glass for the d base tank from? Saw the d base with the sophia and its a great deal. I will be getting them when the cups are back in stock. I have the metal tube for slim tank and it looks great but I dont like having to switch tanks for different juice so looking for glass.

I KNEW I could trust yankee to step in and save the day while I was gone! Just glad you got a timely answer!

 

[thewomenfolk]

More by Leo stuff and Reo's

I have gone so overboard on both that I seriously feel guilty. But it's a happy guilty.

 

[Billie-cig]

Hey Billie, haven't been around much but wanted to check in to see what the status of the new dripper?

Sent from my LG G3 using Tapatalk Pro

No progress unfortunately, since everything is closed until Monday.
They wont like it when they see the work that built up on them, but we will stay at the CnC all morning, to make the first altered parts for the new Dripper ( SS cup - poles, etc.)

 

[NeoGoldenBoy]

Thanks a lot, everyone.

I've been using my Dripper pros on my Provari quite a lot, and I have 2 IBTanked tanks (with a cartomizer) for when I want to have lots of juice, so a Sophia would be even better.

While the IBTanked tanks are awesome, I've been looking for a tank with good capacity (3 to 6 ml) that matches the ProVari even better (and of course of glass.) I haven't found one I like so far, just plastic ones, so I might keep looking out there.

As for the Drippers, I love them, I just want to know if it's ok to rebuild with Kanthal only (I know PBusardo did it, but I've read it's not recommended.)

I'm planning to make an order for a Sophia (or two,) some caps for my Drippers (prefer SS rather than the acetal from my Black, and I love the look of the spiral one, and the bell one,) and some SS beck Drip Tips and a Beck adapter, that to start.

And now that I'm here… I remember swing some ceramic cups on a site some time ago that we're for Dual Coils (2 slots)... and my curiosity has just struck me if those would fit (building nicely) in my ByLeo products.

 

[Billie-cig]

Thanks a lot, everyone.

I've been using my Dripper pros on my Provari quite a lot, and I have 2 IBTanked tanks (with a cartomizer) for when I want to have lots of juice, so a Sophia would be even better.

While the IBTanked tanks are awesome, I've been looking for a tank with good capacity (3 to 6 ml) that matches the ProVari even better (and of course of glass.) I haven't found one I like so far, just plastic ones, so I might keep looking out there.

As for the Drippers, I love them, I just want to know if it's ok to rebuild with Kanthal only (I know PBusardo did it, but I've read it's not recommended.)

I'm planning to make an order for a Sophia (or two,) some caps for my Drippers (prefer SS rather than the acetal from my Black, and I love the look of the spiral one, and the bell one,) and some SS beck Drip Tips and a Beck adapter, that to start.

And now that I'm here… I remember swing some ceramic cups on a site some time ago that we're for Dual Coils (2 slots)... and my curiosity has just struck me if those would fit (building nicely) in my ByLeo products.

The resistance only setup can be done in THE Dripper, but it is not recommended as it will rise the temperature and it might melt (disfigure) the insulator after chain-vaping.
The cups that have 4 slots instead of two, will fit in THE Dripper and the ΣΟΦΙΑ, but in the ΣΟΦΙΑ the threaded wings go almost all the way to the top and it would be difficult in that small space to do cross-type dual coils. I am not saying it is impossible. Jut not practical and difficult.
Usually in the ΣΟΦΙΑ, a parallel dual-coil would be easier, with the wick pointing at the gaps between the wings.
In THE Dripper you can do it with no problem.
I don't know where you can find those cups though.

 

[Train2]

There are a few great glass tanks for a Sophia/ProVari setup!
You gotta take a look at The Cage - it's a solid performer, and it's ByLeo!
You could also consider an SnP, a top quality tank which has a 23MM and ProVari "skirt" options that cover the taper, making a really nice look.

Thanks a lot, everyone.

I've been using my Dripper pros on my Provari quite a lot, and I have 2 IBTanked tanks (with a cartomizer) for when I want to have lots of juice, so a Sophia would be even better.

While the IBTanked tanks are awesome, I've been looking for a tank with good capacity (3 to 6 ml) that matches the ProVari even better (and of course of glass.) I haven't found one I like so far, just plastic ones, so I might keep looking out there.

As for the Drippers, I love them, I just want to know if it's ok to rebuild with Kanthal only (I know PBusardo did it, but I've read it's not recommended.)

I'm planning to make an order for a Sophia (or two,) some caps for my Drippers (prefer SS rather than the acetal from my Black, and I love the look of the spiral one, and the bell one,) and some SS beck Drip Tips and a Beck adapter, that to start.

And now that I'm here… I remember swing some ceramic cups on a site some time ago that we're for Dual Coils (2 slots)... and my curiosity has just struck me if those would fit (building nicely) in my ByLeo products.

 

[StrikeIII]

No progress unfortunately, since everything is closed until Monday.
They wont like it when they see the work that built up on them, but we will stay at the CnC all morning, to make the first altered parts for the new Dripper ( SS cup - poles, etc.)

That's right. i forgot about the August Holidays. My apologies, Carry on...

 

[Billie-cig]

That's right. i forgot about the August Holidays. My apologies, Carry on...

No problem!
I am getting 3 days off this weekend and tha't that for me
I hope I can get online from somewhere there

 

[yankeebobo]

For those looking for dual coils, I have setup a very solid performer before twisting 2 NRs together. (See pic).

Also, taking the gauge of your choice, folding over one end and twisting wire using a drill vapes quite well.

With both methods, zapping is difficult so manual twisting may be the only option.

Keep in mind my wick in ceramic is even shorter than this.

Also. Duals can be done via traditional method. But two wires up the center of ceramic can cause a break.

 

[Billie-cig]

Thanks yankee!
Awesome as always, sir

 

[BK_Malik]

Hey everybody,
I don't have a spot welder and I really have trouble making microcoils with the ready wires that I have bought from two different vendors. The coils always come too narrow and are too flimsy. If anyone with a spot welder would be willing to make me some kanthal microcoils I would gladly pay fpr them. Or if anyone could recommend a place to buy coils that would fit in the Sofia that would work also. Thanks!

 

[Gabiano87]

I was having trouble to with ready wires at the time and wasn't really satisfied sometimes with the vape. Twisting my ready wire gave me a good run for a while but I eventually got a welder. Mine was more expensive than my sophia so It is quite a shocker : ] Anyway if you can save up I recommend getting one. I stalled as the price was so high but makes life really easy. Good luck, will be interesting if you could try a few sent to ya. Over in Uk so not very practical.