-
Need help from former MFS (MyFreedomSmokes) customers
Has any found a supplier or company that has tobacco e-juice like or very similar to MFS Turbosmog, Tall Paul, or Red Luck?
View thread
By Leo : Attys, mods, Drip-tips, tanks [CLOSED}
- Thread starter Billie-cig
- Start date
- th_trl_thread_readers 0
- Status
Is the "7mg" wire cut to a specific length? I mean couldn't any wire gauge be 7mg, depending on the length of the wire? Trying to wrap my head around that
(need coffee and a vape ....)
Last edited:
The Calix (510 - P3 side AF base hasn't been released quite yet) is 37.6mm tall without DT per the ByLeo website. Looks like it is out of stock
.The part with the black acetate, I would just soak it in warm soapy water and scrub if needed, no alcohol. I scrub the chimney's interior using a cotton swab (Q tip) with alcohol and wash clean. Wash the rest of the parts with warm soapy water.
The tank, I just take it apart and run it through hot tap water.
The reason one could not use alcohol with the Calix's tank was due to the glue used to hold the steel to the glass. Hope it helps.
@stanleybb50 could it have been the 29 GA causing the high pitched sound coming off you're radius? LOL
Is the "7mg" wire cut to a specific length? I mean couldn't any wire gauge be 7mg, depending on the length of the wire? Trying to wrap my head around that
The "7mg" were reffered to HB's post. He said - only 28 or 30g, bottom line etc. Well, I use ONLY 0,38mm (~27g) and 0,32mm (~28g).
R
7mg was referring to the nicotine content of juice. Go back and read the comment again!
You must need coffee, and a vape!
Hahahaha!!!
You must need coffee, and a vape!
Hahahaha!!!
Lol. No this is the first time I've used it. And I'm on a p3 at the moment with no high pitched sound
It doesn't bother or concern me though - fyi
Sent from my SM-N920V using Tapatalk
Inspired by an AndrewWVid I now use an 18ga needle to make microcoils using 28ga wire to fit in ceramic cups as shown above. The coils have 11 wraps and barely fit in the cup at my target resistance. I had considered purchasing 29ga wire so I could use less wraps and fit the coils with more room in the cups, but I've settled on my current build instead. I guess that I was initially surprised when I first looked for and found odd numbers of wire gauges, but it seems like they could come in handy in some cases.
I just use warm water with a bit if dish soap and paper towels and a very diligent rinse to clean my atomizers. I use paper towels and wipe down and wash off each individual part. I typically clean every few days without disturbing the coil and when I rebuild I clean off the contacts and deck real good.
Last edited:
Straight through! It's tiny, but it's there, and it works! I've had to do it myself!18ga needle?
Just got the first side air flow bases for the Calix. If everything goes well tonight, they will go into production tomorrow
This is amazing news!!!Just got the first side air flow bases for the Calix. If everything goes well tonight, they will go into production tomorrow
Can't wait to see them Billie!!!
I'm sure they are beautiful, like all the ByLeo family!!!!!![emoji7][emoji7][emoji7][emoji7][emoji7]
Fantastic Billie! Is that just the 510 base or is the P3 base ready as well?Just got the first side air flow bases for the Calix. If everything goes well tonight, they will go into production tomorrow
- Status
Similar threads
- Locked
