cartos, clearomizers, atomizers....? Which do you use?

Status
Not open for further replies.

jnnfrlsw

Ultra Member
ECF Veteran
Verified Member
Dec 28, 2009
1,306
459
East Central Ind
I have tried most of the clearomizer types and have not had much luck. 98% of the time they tasted burnt-regardless of which device and voltage/wattage. Also, the flavor was very muted. Today, I received the Kanger EVOD and after 2 refills I am still pleasantly surprised. Not a single burnt taste-on several devices as well as various voltage/wattage setting. And the biggest surprise is how flavorful my juice tastes. Besides the EVOD, for the past 2 years I always ended up staying with either a boge or a dualcoil carto-with 2 or 3 holes punched and in a carto tank. In my experience that setup gives me the most consistant hit and best flavor. For sure they involve more time tinkering than the clearos but just perform better for me. Again the new EVOD is looking promising though.
 
T3's !. I just change the coil base before every refill. Stops "frying" the juice especially if i only half fill the tank. Now the fluid stays clear right down to the end. I recoil when they break, saves buying new ones. Recoiling a T3 isn't easy though. But i am perfectly happy with T3's. Good flavour plenty of vapour and with the right juice a nice smooth th using 100% vg 3.6 - 4.5 mg nicotine. Menthol is excellent !. To recoil a T3 i cut the ends off of a cue tip and slice down one side with a razor blade then open it up. Soak the wick in glycerine and place it in the open tube then roll it in my fingers to make to tube tight. Then i get another two cue tip tubes and slide each onto either end of the split tube to keep it tight. Tightly wrap Kanthal wire round the split tube a few times then dismantal the whole thing and slide the coil onto the wick. It's all pretty fiddly. If you folks can wrap a coil round a wick without shredding the wick i'd like you tell to me how you do it. The way i am doing it works fine. Is there an easier way ?.
 

indianajames

Super Member
ECF Veteran
Verified Member
Feb 16, 2013
623
868
59
Mission, KS
Boge dual-coil cartos, DCTs, and for dripping, 510 (single- and dual-coil) and a 306. I've never tried a clearo.

I'm finding that some flavours rock when dripping or in a tank, but once I put them in a carto they taste lame, even though they still produce good vapor. Not all flavours, just some of them.
 

Vapoor eyes er

ECF Guru
ECF Veteran
Sep 13, 2011
11,028
8,945
Toronto, Ont.
When I first began vaping I used Boge 2.0 ohm single coil cartos (1 ml). After 1 month I switched to Smok Tech XL 1.7 single coil cartos (1.8 ml). Next I used a carto+and tank (3ml) setup. When the cracking and wicking issues were resolved I got into Startdusts (1.6 ml). I now use the Mini Vivi Nova (2.0 ml) rebuildables as I feel they give a better draw and are far superior in quality. It is VERY important to match the correct ohms delivery device to the PV we are using otherwise, dry hits or a weak vape will occur.
Although I my main delivery device is the Vision Mini Vivi Nova I occasionally treat myself to a Smok Tech XL 1.7+ tank on occasion.

-how many fills do you use before you clean/throw out
Cartos on their own last about 1 week

Cart+ tank. Carto lasts before tight draw begins:
dark juice- 50- 60 ml
light juice- 80-90 ml

Vision Min Vivi Nova- at least 8+ weeks with some maintenance- still firing at that point but wicks beginning to shred.

-how is flavor
Flavor best on an atty. Next carto and finally Vivi Nova. I found tanks weaken the flavor so I add extra flavor.

-resistance levels or do you think it matters
Res makes a HUGE diff. I like a warm vape and use 1.8 ohms at 3.7- 4.0 volts. Here's a voltage/ ohms chart:
http://25.media.tumblr.com/tumblr_m9dkanCt0I1qc8949o2_1280.png
 
Last edited:

gordk

Full Member
Verified Member
Feb 2, 2013
59
38
Roxy and Elsewhere
...When I first began vaping I used Boge 2.0 ohm single coil cartos (1 ml). After 1 month I switched to Smok Tech XL 1.7 single coil cartos (1.8 ml). Next I used a carto+and tank (3ml) setup. When the cracking and wicking issues were resolved I got into Startdusts (1.6 ml). I now use the Mini Vivi Nova (2.0 ml) rebuildables as I feel they give a better draw and are far superior in quality. It is VERY important to match the correct ohms delivery device to the PV we are using otherwise, dry hits or a weak vape will occur.


Cartos on their own last about 1 week

Cart+ tank. Carto lasts before tight draw begins:
dark juice- 50- 60 ml
light juice- 80-90 ml

Vision Min Vivi Nova- at least 8+ weeks with some maintenance- still firing at that point but wicks beginning to shred.


Flavor best on an atty. Next carto and finally Vivi Nova. I found tanks weaken the flavor so I add extra flavor.


Res makes a HUGE diff. I like a warm vape and use 1.8 ohms at 3.7- 4.0 volts. Here's a voltage/ ohms chart:
http://25.media.tumblr.com/tumblr_m9dkanCt0I1qc8949o2_1280.png

I have a Mini Vivi Nova and it's the only thing I've tried that has a wick and that I genuinely like. My first pair of carto + tank lasted about a month. Not sure what I did right then or what I'm doing wrong now.

"2mg X 15 ml per week" Perhaps part of my problems lies here. That's 30 mg, which would take me maybe 3 hours....
 

Vapoor eyes er

ECF Guru
ECF Veteran
Sep 13, 2011
11,028
8,945
Toronto, Ont.
I have a Mini Vivi Nova and it's the only thing I've tried that has a wick and that I genuinely like. My first pair of carto + tank lasted about a month. Not sure what I did right then or what I'm doing wrong now.

"2mg X 15 ml per week" Perhaps part of my problems lies here. That's 30 mg, which would take me maybe 3 hours....

Have used them for 6 months...at one point was getting 300 ml out of each head. A friend prolly puts about 500 ml through his before he changes the head.
 
Status
Not open for further replies.

Users who are viewing this thread