Cartos for "Inferno" batteries from Volcanoecigs?

[Drewps5co0tt]

Hey,

I just got the latest "Inferno" kit from Volcanoecigs, they recommend 1.5-1.8ohms for the batteries for the best production. Only problem is they are going to stop selling their cartos after their supply runs out, they say everyone is moving to BC coil setups (which is a bummer for me because I prefer cartos to anything else.) I use to use BOGE on my VV device but they don't seem to make cartos in anything lower than 2.0ohms so I wanted to know if anyone made them in 1.7 or 1.8 ohms in either the regular size or the XL size (I might be getting a longer tank that requires the XL size and I can't seem to find anything online. I can punch my own holes btw

Thanks!

P.S. Stainless and single coil is a must (I can't take DC they rip my throat to shreds.) Oh also I meant to ask...would I get good results if I just used a 2.0ohm carto? Is there really that much of a difference between 1.8 and 2.0? Currently I'm using the 1.8ohm single coil bc coil system but I'm not a fan of it because every time you take draws on it it sucks up juice thru the air shaft into the drip well that sits just below the drip tip, it's big time annoying!

 

[Spazmelda]

Try looking for smoketech 1.7 ohm cartomizers. Like: Smoktech 1.7ohm Single Coil Blank Cartomizers

I'd also recommend starting to try out some clearos in a search to find one you can use, because I suspect that cartos are going to get harder and harder to find. Jmo, maybe I'm wrong!

 

[Drewps5co0tt]

Your link is bad

BTW are all clearomizers top coil? I remember trying some a while back and they were just too damn hot for me...they also spit juice all over the place. For some reason I've only had good luck with cartomizers.

 

[Spazmelda]

I'm sorry the link didn't work. Just try googling smoketech 1.7 ohm stainless cartomizers. That should bring up some links for you.

Not all clearos are top coil. I never liked top coil myself. You could try an evod, a protank, or a nautilus. There are quite a few bottom coils clearos to choose from. I switched over from protanks to a Kayfun myself (which is essentially a bottom coil rebuildable tank). I don't really keep up with the new bottom coils that come out, so I don't know what's the preferred tank these days. Maybe start a thread asking for recommendations for bottom coil clearos and see what people say.

 

[vjdossey]

you can get cartomizers in a LOT of places. I usually order from surevapes. yesterday i placed an order with madvapes. You can check the supplier list on ECF and seriously MOST vendors have cartomizers. I do not think there is any risk of them going extinct anytime soon!

Hey,

I just got the latest "Inferno" kit from Volcanoecigs, they recommend 1.5-1.8ohms for the batteries for the best production. Only problem is they are going to stop selling their cartos after their supply runs out, they say everyone is moving to BC coil setups (which is a bummer for me because I prefer cartos to anything else.) I use to use BOGE on my VV device but they don't seem to make cartos in anything lower than 2.0ohms so I wanted to know if anyone made them in 1.7 or 1.8 ohms in either the regular size or the XL size (I might be getting a longer tank that requires the XL size and I can't seem to find anything online. I can punch my own holes btw

Thanks!

P.S. Stainless and single coil is a must (I can't take DC they rip my throat to shreds.) Oh also I meant to ask...would I get good results if I just used a 2.0ohm carto? Is there really that much of a difference between 1.8 and 2.0? Currently I'm using the 1.8ohm single coil bc coil system but I'm not a fan of it because every time you take draws on it it sucks up juice thru the air shaft into the drip well that sits just below the drip tip, it's big time annoying!