Change Coil Resistance

Status
Not open for further replies.

ClippinWings

Ultra Member
ECF Veteran
Verified Member
Dec 12, 2011
1,641
1,889
The OC
sure.

But realize by dropping to 1.2, you'll likely find it a warmer vape.

Changing resistance, as you've surmised, changes flavor... this WILL also be true of the juices that do work fine for you now at 1.5.

The other factor, could be PG/VG level... higher PG juices carry flavor better, higher vg juices produce more and thicker vapor.
 

readeuler

Ultra Member
ECF Veteran
Verified Member
Jul 17, 2014
1,203
1,945
Ohio, USA
I'm not sure that an EVOD battery will recognize 1.2 ohms as a valid reading. I think it will be below the battery's build-in short protection threshold, assume you have a short, and refuse to fire. It might fire, but don't be surprised if it doesn't.

The EVOD 2 is dual coil, isn't it? On my eGo battery, I don't enjoy dual coils very much. I rarely get good flavor/vapor production, because dual coils split the battery-supplied power between the two coils. For that reason, you may want to try something single coil, like the original EVOD BCC (it's becoming my favorite clearomizer for a fixed voltage eGo battery).

This will generate the same amount of vapor-producing heat as the EVOD 2, but it will be concentrated on a single coil. I find this to give more vapor, and I prefer it, personally.
 

Susan~S

ECF Guru
ECF Veteran
Verified Member
Mar 12, 2014
16,937
11,694
68
Mpls/St.Paul, MN
I'm not sure that an EVOD battery will recognize 1.2 ohms as a valid reading. I think it will be below the battery's build-in short protection threshold, assume you have a short, and refuse to fire. It might fire, but don't be surprised if it doesn't.
And if it does fire you may fry the batteries circuity. Most "Ego type" batteries have a 2.5A limit.
 

facedown

Senior Member
ECF Veteran
Aug 13, 2014
137
144
Highland Park, IL, USA
And if it does fire you may fry the batteries circuity. Most "Ego type" batteries have a 2.5A limit.

It took me a while but I finally found the factory specs for the 1000mAh model. It's actually 3A but that would limit R to just above 1.2 ohm so it's not worth it. I'll just try those juices again when I get a higher wattage rig.

Thanks Susan~S and all else who replied!
 
Status
Not open for further replies.

Users who are viewing this thread