changing liquids for CE4+

[farmer]

hi guys, was wondering if anyone could advise what you do when you change flavours (when using CE4+).

I've checked out how to clean these attys but to what extend should it be cleaned when filling it another flavour.

pls advise! thanks!

 

[wultan]

Normally, i would just rinse it under running water, fill it up , give it a goos shake. Do this a couple of time until you can see the wick sticking out if clean and white. Let it dry overnight. An finally do a dry burn before filling with new liquid/flavor.

 

[ikelvin]

Normally, i would just rinse it under running water, fill it up , give it a goos shake. Do this a couple of time until you can see the wick sticking out if clean and white. Let it dry overnight. An finally do a dry burn before filling with new liquid/flavor.

thanks for the tips i just tried your method lol

 

[wultan]

Ok... I think I will have to change what I initially said.
Dry burning is a very touchy thing. The 2nd CE4+, I think I dryburn too long and the burnt taste actually remained even after letting it saturate over night. I think the problem is that i dryburned it until i see it light up bright red repeated times.

For the 2nd CE4+, i dryburned it until i could see the the coils turing red ONCE, then i stopped, which seemed to help.

 

[farmer]

thanks for the top wultan. do you dissemble it when u wash?

 

[wultan]

Nope. I do not dissemble them to wash. Just rinse the whole unit under running water.

On another note; I just got a box of ce4+ from microcig and they differ from the ce4+/Vision stardust version. The inner tube is smaller in diameter and the whole unit is actually about 1/2" taller. vaping the microcig's ones presents an almost similar experience, except for the draw. It is so much smoother!