Changing resistance

[Zutankhamun]

All of my atty's stay at the same resistance when I use them but my kayfun lite+ changes. Not noticeable, only on the 2nd decimal place. I have tightened the 510 pin completely, my screws are as tight as can be and my wire is perfect. It was only happening on the rdna at first now it is the same on my 150tc. It slips back and forth between 1.26 and 1.30. But no other atty is the same. any ideas?

 

[3mg Meniere]

You are right. It is not a significant change.

 

[Zutankhamun]

Thanks, I know that. Do you know why though.

 

[3mg Meniere]

Random error of measurement, most probably.

 

[puffon]

As my coil gets caked up, the resistance will rise slightly.

 

[Zutankhamun]

K, thanks guys. This coil is brand new. I know it's nothing to worry about but it really annoys me. Doesn't do it on every device. Just some. Cheers neway. And those same divices other tanks don't do it so it's not faulty devices

 

[Zutankhamun]

Aha! I always fill it from the top and hold my finger over the air hole. The chimney bit had unscrewed slightly. Seems to be fine now.