- Status
It is. It's geekvape MTL 316L 28*2 parallel +38. 9/10 wraps, 2mm ID, 0.467 OHM, 12w MTL vape.
Should probably go 2.5mm, or a hair bigger, and a couple fewer wraps.
I'd definitely experiment with 2.5mm ID @HigherStateD, as that must get a little bit on the warm side.
Not at 12w. 15 is warmish if I chain it. 30 with restricted dtl is kinda nord like.
So that coil was pre-made? I agree (but what do I know?) 2.5 ID and a few less wraps. I been doing some reading about making coils and curious what it means to "stress" the coil when wrapping (I'll be using regular round kanthal wire) I assume it just means to keep strong pull on the wire as you wrap, or is there more to it?
It's a pain sometimes refining the build for an atomiser though, as what works well in one doesn't work well in another.
It's mainly down to airflow, heat capacity and coil mass.
It's mainly down to airflow, heat capacity and coil mass.
@vaper1960, when they say strain they mean tension. So when wrapping the coil keep the wire pulled reasonably tight.
- Status
