RDA Concern about RDA's center pin

[Danny_uk5]

Hello again!

I have bought myself a fine rda but I'm alittle worried about the center pin on the rda. My concern is based on the fact it can't adjust outwards and I am worried about a dead short on my mechmod.

Imgur: The most awesome images on the Internet

http://i.imgur.com/5Z73YBx.jpg

This is another one for refrence, this one below is a real deal !

Imgur: The most awesome images on the Internet

Should I return the rda in favour of one that I can adjust or will it be fine ?

 

[rolf]

there are tons of attys with the center pos pin not adjustable .
would be nice to try it on a regulated mod if you have one.
I would not expect a problem with it so . a short burst on the firing botton will tell you in a hurry.

 

[Danny_uk5]

there are tons of attys with the center pos pin not adjustable .
would be nice to try it on a regulated mod if you have one.
I would not expect a problem with it so . a short burst on the firing botton will tell you in a hurry.

I've got a sigelie 150 that I test all my of builds on. It does have short protection and a ohm's reader, so it's really handy at the end of the day. It's my go to for everything.

I'm gonna build on it and see what my sigelie says. I've just read one too many horror stories of people putting none adjustable centre pin tank on a mech mod and ending up in hospital.

 

[KentA]

The 1st picture shows the center pin does protrude.
It doesn't take much to create an open circuit.

 

[bwh79]

You're confusing "mech mod" with "fake hybrid topcap/direct-atty-to-battery-connection mech mod." It's only the second kind that requires a protruding center pin on the atomizer.

 

[Danny_uk5]

Still, it was wise of me asking if you ask me as I kinda like my face.

Hybrids are something I stay clear of. I had a bad run in with a dreadnought clone and stayed away from that point.

Many thanks!

 

[bwh79]

Still, it was wise of me asking if you ask me as I kinda like my face.

Absolutely. If you don't know, the only way to find out is to ask. I suppose you never said what kind of mech you had, I was just pointing out that they're not all as dangerous as some of them can be.

 

[WharfRat1976]

Hello again!

I have bought myself a fine RDA but I'm alittle worried about the center pin on the RDA. My concern is based on the fact it can't adjust outwards and I am worried about a dead short on my mechmod.

Imgur: The most awesome images on the Internet

http://i.imgur.com/5Z73YBx.jpg

This is another one for refrence, this one below is a real deal !

Imgur: The most awesome images on the Internet

Should I return the RDA in favour of one that I can adjust or will it be fine ?

Just make sure the center pin of your mod lines up dead nuts with the center pin on your atty and you are good to go. Make sure all of your screw downs...button, top piece of your mech and atty to the mech all are perfectly lined up.