I have been vaping since December on a KR808, I haven't kicked the analog habit as of it yet severely put a dent in in. I want to stay with cartomizers which your site has had the best information on Cartomizers that I have found. I am curious on upgrading to either a Riva 510 or Ego but looking through all the information I am going through information overload. So I would like to take the time to ask a few or couple of questions.
1. I want to use the cover will there a problem using the atomizer cover over the carto without effecting airflow or for that matter, will they fit over the cartomizer.
2. I have only seen 1 510 kit even remotely set up for cartomizers so is it taboo to use a cartomizer for a 510.
Thank you for your patience and time. I beginning to think that the internet can be a curse at times/
I have been using an ego for about a month now, and am waiting for some 5v goodies to arrive. With regards to your questions...
1. As Isaac said, sort of. There are several cartomizers that will be very restricted when using the cone. The mega 510 LR is one of them. It is a very tight fit and very little air gets through, causing additional heat and a very tight draw. The first LR 510 I used went kaboom because of this. On the other hand, the V2 Gold Drip style and non drip style work fine with the cone. As do the first generation gold cartomizers. It is going to be trial and error but you will find what works best for you.
2. You can generally use cartomizers on all 510 batteries. There are recommendations to not use low resistance cartomizers on any battery below 350mah because low resistance cartos/attys will drain the battery faster.
Side note: coming from a KR808 - the ego is closer in voltage, and the riva is stronger than what you're used to. I say skip both of them and try a box mod. It is much cheaper than getting one of those two starter kits and you can reuse the batteries in another mod if you upgrade. If you're handy with a soldering iron and hot glue / epoxy you can get all the parts to build your own box mod for 10 bucks.
Here is one example. If you would rather buy a premade box mod, then you could do something like
this. If you're looking for something that is visually appealing then I would say go with the ego passthrough. It has a battery in it but also uses a typical usb cable to charge - and can be detached. It doesn't have to stay hooked up to a usb port... and that's what I use when I am at work. It's cheaper than buying a starter kit.
Good luck and happy vaping. As always, don't be afraid to ask questions. We were all new to this at one point or another.
