cool fire iv PLUS purchase question

[PoPoPoP]

I just purchased it and got it today.
I opened it, everything seems authenticate. I used the code on website n they said its legit.
But when i use it, the battery indicator shows full bars ALWAYS...even after hours of vaping. Whats going on?

 

[JayPut]

I used to be able to get about a full day to a day and half of all day vaping on my cool fire. especially if i didn't use it while it was charging.

 

[Susan~S]

What power level are you vaping at?

 

[JayPut]

when i had a cool fire it had a built in battery so i am not sure what battery it was. but i usually vaped around 30 - 35w. now i use a sigeli 200w, i am using efest 18650 2900mah and i vape on either my airek or mutation v4 at usually around 80w for a .36 dual coil clapton build.

 

[PoPoPoP]

I vaped on 3.9V. But somehow I got burnt taste, so threw away the coil n using another one. Vaping on 3.6 now.
THE BATTERY LEVEL STILL SHOWS FULL.
I swear, I vaped a lot today...
Is this devcie faulty?

I still don't get it. WHen device arrived to me, i thought I needed to charge it. But no, it was already full... Company charged it? Is there any way to fix this error?

 

[herb]

Innokin makes fantastic mods , thats how my Innokin mods are also , be happy.

 

[gandymarsh]

The Coolfire IV Plus has a 3000 mah battery. It should last 50% longer than the first Coolfire IV. 3.6 v is quite low. I assume you're still using the Aerotank which has a fairly high resistance coil. It's probably normal for it to show a good charge yet.

 

[PoPoPoP]

The Coolfire IV Plus has a 3000 mah battery. It should last 50% longer than the first Coolfire IV. 3.6 v is quite low. I assume you're still using the Aerotank which has a fairly high resistance coil. It's probably normal for it to show a good charge yet.

Yeah, you have a good memory!! I'm still using the Aerotank. My new tank hasn't arrived here yet... So I'm using the aerotank with 1.5ohms dual coils.
Hopefully ur right. Hopefully this isn't faulty

 

[JayPut]

I vaped on 3.9V. But somehow I got burnt taste, so threw away the coil n using another one. Vaping on 3.6 now.
THE BATTERY LEVEL STILL SHOWS FULL.
I swear, I vaped a lot today...
Is this devcie faulty?

I still don't get it. WHen device arrived to me, i thought I needed to charge it. But no, it was already full... Company charged it? Is there any way to fix this error?

try lowering your voltage... my advice start low on volts and slowly work your way up until you find the sweet spot. as far as the battery, keep vaping it until it dies and see what it reads then. as long as you battery is not getting hot you should be ok. if it will not vape any more and it is still reading full charge then i would say yes it is a faulty battery. You will be surprised at how long a innokin battery will last.

 

[PoPoPoP]

try lowering your voltage... my advice start low on volts and slowly work your way up until you find the sweet spot. as far as the battery, keep vaping it until it dies and see what it reads then. as long as you battery is not getting hot you should be ok. if it will not vape any more and it is still reading full charge then i would say yes it is a faulty battery. You will be surprised at how long a innokin battery will last.

3.7~3.9 is the sweet spot for 1.5ohms dual coils, at least for me.
I used to use MVP 2 for 2 years and i used these voltages.
Hmm,, I suppose each battery is different...

 

[gandymarsh]

Aerotanks can't handle high voltage/wattage. A Nautilus mini with a 1.8 or 1.6 ohm coil can handle 12-13 watts which comes to ~4.5 volts. I use my Eleaf GS Tank with a 1.5 ohm dual coil at 5 volts/17watts.

When you get the Subtank, depending on the coil you use, you'll be going up even higher.

I would suggest you change your display from volts to watts. In watts mode, it will adjust the volts to fit the atomizer resistance.

 

[Romenov]

vaping until it's really exhausted.. if it's still showing full bars all the time, return it

 

[djsvapour]

The battery bars are often not reliable. No two mods are the same on this.
Maybe it stays on 100% for a long time and then bombs faster than you can say 4....3...2...1 dead

 

[PoPoPoP]

Ok, the battery level isn't faulty. It finally showed no bars at the end.
But I got a question.

I use a 0.5ohms coil (the brand says it is), but the oms meter on coolfire actually shows 0.66 ohms. Same issue with my other coils (1.5ohms kanger dual coils actually showing 1.68~1.7ohms).

 

[djsvapour]

Ok, the battery level isn't faulty. It finally showed no bars at the end.
But I got a question.

I use a 0.5ohms coil (the brand says it is), but the oms meter on coolfire actually shows 0.66 ohms. Same issue with my other coils (1.5ohms kanger dual coils actually showing 1.68~1.7ohms).

No problem there.

That's exactly the sort of readings I would expect to see.

 

[Frenchfry1942]

Factory made coils are usually a bit off on resistance.

As to the bars, Innokin is a good company. Sometimes they are slow to keep up with current capability levels, but when they do put out a product, it is usually built better.

One thing I have noticed with low and mid-level brands is that the battery level indicator is like my car gas gauge. It ain't exact. Just get a feel for how long it lasts by your vaping. Keep in mind the resistance and power you use. I had two MVPs and used one while the other was charging.

Good mod.

 

[gandymarsh]

Yeah, my iSticks always show the ohms a point or two higher. My cheapo Kangside Vamo mini 25w is usually dead on.

 

[djsvapour]

Yeh, my VW (that's a car) says it only gives off low emissions.

Proving that vape coils and German cars aren't very accurate.

Remember, "one cartomizer equals 85 cigarettes"