- Status
Interesting. Do you line your cotton even with the top or stack the cotton high and wide?
You can go over the top. Do a Scottish roll and just tuck it gently down in, flavor is fantastic. Great with twisted 30 gage. You can do as many loops as you want. With 28 gage 2 loops comes out to .5 ohms. Ofcourse it depends how big you make it. Pics coming in a fuew minutes.
The first part is done by hand, then wrap it around whatever your using, but you want the dish to be nice and round at the bottom. You can use a tweezers to make the loops thinner for a warmer vape, do this before wrapping it around your screwdriver or whatever.
Was wondering how extra cotton would do since there's nothing restricting the size.
Hmm, Interesting. Maybe call it the infinity cradle coil.
I'll try it on my old mod that needs higher ohmage.
I'll try it on my old mod that needs higher ohmage.
You can get any ohms you want using 2 3 or 4 loops when you bend it with your hands. With 28 gage 2 loops is .5....3 loops is .8. These fit the clieto 120 perfectly.
A thing of absolute beauty! Just tuck that cotton in. Works great with the side airflow on this one. And having no top, works great with a bottom air flow rta. The top of your coil runs hot if air only hits it from the bottom. Therefore this design works better, it has no hot top. You don't want that hot top if the coil is close to your mouth, as in current rta's drippers whatever. This coil produces clouds at 17 watts that you wouldn't expect. Well at 4.
2 volts on a mech .8 ohms I even get a nice sized cloud. That's a low wattage for sure. The power of the coil is more focused on the cotton, which is easier to fit into the coil, while having more control over your vape. The ramp up time is quick with this design too, at .5 ohms with any wire it's instant. Good God I'm done now. Hope someone builds this and likes it.
2 volts on a mech .8 ohms I even get a nice sized cloud. That's a low wattage for sure. The power of the coil is more focused on the cotton, which is easier to fit into the coil, while having more control over your vape. The ramp up time is quick with this design too, at .5 ohms with any wire it's instant. Good God I'm done now. Hope someone builds this and likes it.
- Status
Similar threads
