So i had finished sanding them (i was using my bench top belt sander). Then when i was polishing them i noticed there were high and low spots created by the sander that showed bad on them so i've been taking them to a true flat with sandpaper lying on a true flat surface. I hope to have them ready to send out in a week. I really morally couldn't just half ... it just to get people off my back especially after you've all waited so long. I'll be drafting up an email for everyone that ordered and will be doing something very special for all of you (something i've never seen offered by anyone before) to show again my appreciation for this whole ordeal
I think there is a about 50+ pre paid flairs, I would like to suggest that we all donate a few extra dollars to Brad to help offset time and suffering and diligence. If anyone else feel the same please PM me.
I'm not suppose to be doing this but I am. We've heard from Brad (another forum) and everything is fine with the Flairs. We need to just hold tight for a bit longer. That's all I know plus I've seen them all finished.
Brad gruss had sent out an email to me stating that the Flair mod will be shipping out by end of this week. Any of you got the same good news? Better check ur inbox!
I got no e mail at all from brad or sweetvapes,brad also said a month ago that they would be shipping in about a week.I'll believe it when it gets here,along with the AFPV and scubagen mini.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.