Diy juice how much flavoring to use.

[Tango550]

Very useful I don't think I put in enough flavoring when I make my juice. I've been putting 1ml pg 1ml vg and 1 ml nicotine then about 15 drops of flavoring but hardly get a taste. Any help out there someone said to put the juice in boiling water to bring the flavor out I'm gonna try that now.

Thanxx

Keep on vaping

 

[rockgoddan]

You might need to steep the juice. And try to raise the pg percentage of your juice, I find that 80/20 pg/vg gives more flavor while giving a decent amount of vapor. Also, try to raise your flavoring percentage to 10% or 20%. Good luck and let us know how it turns out!

 

[dam718]

This is very subjective... Making tiny batches like that doesn't offer up a lot of wiggle room.

I also don't like using drops as a unit of measure. But I am also an engineer so I submit to being a perfectionist.

For most of my DIY's I'll start with 10% flavor...

So for a 10ml mix, 1ml will be flavoring.

If you look in the E-Juice forum on the board, there is a DIY subforum, that would be the better place to ask these types of questions in the future Lots of DIY folks there that love to share knowledge

Welcome to ECF BTW!

 

[Jimmyhat]

http://www.ecigexpress.com/ejuice-calculator.php use this webiste to claculate everything, I just started diy last month but I seem to stay around 20-25% flavoring and EM (this is if I mix several flavors) but I think 8-15% of a single flavor should be good. I still havent found where the flavor is the strongest (if you use too much flavoring it tends to act as if it doesnt have enough)

 

[darkhood]

This ^^^

I use 15-18 drops condensed flavor per 1ml vg, 10-12 if it's 50/50 pg/vg.

 

[Tango550]

Thanxx all very useful info.

 

[lulu836]

take a look at this mixing guide