Diy mod

[haggardhawkeye]

Hi everyone I am new to the forum. I have recently gotten very into mechanical mods as of now my setup is a signum copper mod and a nimbus rda I am interested in building my own mech mod but have been having a hard time finding pre machined 510 top connectors and bottom firing buttons is there a site where I can purchase these items or is my best bet going to a local machine shop and having them made


Sent from my iPhone using Tapatalk

 

[PMVapours]

What about buying a cheap mech. from someone like fasttech and using the pieces you need for the construction of your custom mod. I bought a Sentinel M16 clone for around $10 shipped from them.

 

[haggardhawkeye]

Yea that's a very good idea I was looking into doing that and it would be much cheaper than a machine shop it's just a bit lore of a pride thing with having it all custom you know but yea I will probably go that route and just design my own tubes


Sent from my iPhone using Tapatalk

 

[PMVapours]

I understand the wanting it to be all custom, I don't know if it would be possible but could contact a US based company that makes mechs and see if they could produce the parts you want and your design, someone that does small runs of products on their own lathe, or maybe a local tech school that has a machine shop, or look on craigslist for someone that could do the machining for less than a dedicated machine shop would charge, just throwing ideas out there.

Good luck, looking forward to seeing your creation.

 

[haggardhawkeye]

I understand the wanting it to be all custom, I don't know if it would be possible but could contact a US based company that makes mechs and see if they could produce the parts you want and your design, someone that does small runs of products on their own lathe, or maybe a local tech school that has a machine shop, or look on craigslist for someone that could do the machining for less than a dedicated machine shop would charge, just throwing ideas out there.

Good luck, looking forward to seeing your creation.

Thanks I did find top caps and bottom switches on a few sites last night have some on the way might not be the same diameter for the threads but I have an idea to make it look flush whenever the parts come and I get some free time to throw it all together I will for sure be posting some pictures of it thanks for the suggestions I'm sure in the future if everything turns out right I'll be in Contact with my local machine shop


Sent from my iPhone using Tapatalk