My display seems to function fine with 1+ ohm atomizers. I just built a 0.8 dripper and its firing fine, however the display on the dna 30 reads 0.8 and it flashes and does not stop flashing. Why?
DNA 30 Flashing Ohm readout?
- Thread starter ck32250
- Start date
- th_trl_thread_readers 0
- Status
OK, I turned up the wattage and it stopped flashing. Im guessing it was telling me the watts were set too low.
If your watts are low enough on certain builds it makes the volts too low for the dna 30 to push it. When it flashes like that it is telling you the volts are too low. So what you found out by upping the wattage is correct. Doing so will also up the voltage
Sent from my iPhone using Tapatalk
Sent from my iPhone using Tapatalk
jared is right, but it will still fire, its just firing raw battery voltage. You are still fully protected!
Yes, as mentioned, when it is flashing like that, the device is unable to regulate with your chosen settings and will run straight off the battery.
At least that's what I've gathered from the videos I've watched.
At least that's what I've gathered from the videos I've watched.
- Status
