I got my dna 40 build all done and I've been using it for a while but I just noticed that when I take my mod outside the screen will glitch up until it warms back up. I don't think this is the missing green solder because I got the chip after that was supposedly fixed. Any ideas?
Unfortunately, it sounds like you have a glitchy dna40. You will probably have to pull it from you mod and send it back to evolv. They will send you a new one that you get to reinstall. I don't know this for certain but this sounds like some of the problems folks have reported over in: http://www.e-cigarette-forum.com/fo...sion/612272-official-dna-40-introduction.html and they had to replace the chips or return their mods.
You can also return the mod and they will replace the chip. You should advise that yours worked fine until the temperature event as that is useful information.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.