So there I was, just building away, last night. I built a .4-.5ish load in an atomizer and tossed it on my dna30 device. After deciding I wanted to rebuild it, I fired it to clean the juice off the cotton so as to make for an easy clean up. I held the fire button for a bit to do this. After doing this a second time, it stopped firing and showed a 'too hot' message on the display.
I left it to cool down a bit, then tossed another .5 build on it. It immediately just reset when I tried to fire, so I decided that the battery must be dead enough and needed to be recharged. Fast forward to this morning and I tossed the same build on the fully charged device. I tried to fire and it reset. I lowered it to 7W and it reset. I put a 1.6o tank on and it reset.
Now, anything I put on the device will reset it. If i leave it by itself, with no atomizer, it will just say check atomizer when i try to fire (as it should).
Any ideas on why it will not fire? I assume it's because something got too hot and now it's broken, but just wondering if there's something else i can try.
I left it to cool down a bit, then tossed another .5 build on it. It immediately just reset when I tried to fire, so I decided that the battery must be dead enough and needed to be recharged. Fast forward to this morning and I tossed the same build on the fully charged device. I tried to fire and it reset. I lowered it to 7W and it reset. I put a 1.6o tank on and it reset.
Now, anything I put on the device will reset it. If i leave it by itself, with no atomizer, it will just say check atomizer when i try to fire (as it should).
Any ideas on why it will not fire? I assume it's because something got too hot and now it's broken, but just wondering if there's something else i can try.