don't over tighten your equipment!

[jonescreek]

as the title says noobs... best advice I could possibly give you is, don't over tighten your stuff!...when you feel your carto/clearo/tank/atty make contact... whatever it may be.... give it about a half turn more and it will save you alota problems!. And welcome to ECF

 

[Greaser55]

good advice, just got my first setup today and that question was floating around in the back of my mind.... "how tight is too tight?" now I know, thanks!

 

[DJAMiller]

Truth, I've already broken an Ego battery with my drunk kung-fu grip!

 

[elscorcho]

Great OP...I learned this the hard way! I wondered why I couldn't find a clearo that didn't leak.

 

[brock957]

I heard this at first and it's good advice. A friend of mine killed a battery by over tightening it and having to pop the tip back up multiple times.

 

[tnt56]

First I'd like to welcome all to ECF. If you bought your device from a local B&M shop then they should have explained this when you bought it. If they didn't then I'd find another place to buy from. Or better yet: Come here to ECF and ask questions about things your unsure of.
Remember the only stupid question is the one you don't ask about. We'll help with all the knowledge from all over the WWW.
Happy vaping and best wishes to your new life.

 

[AlexisLuvsU]

Learned the hardway. I now have a circle from over tightening on my center post. It's still safe to use right?

 

[Gus Morgan]

good tip, probably saved me a few tanks learning this before I started vapoing

 

[jimrug1]

as the title says noobs... best advice I could possibly give you is, don't over tighten your stuff!...when you feel your carto/clearo/tank/atty make contact... whatever it may be.... give it about a half turn more and it will save you alota problems!. And welcome to ECF

Great Advice! You have to fight the tendency to over tighten. As i said in an E-Cig specific terminology thread. Do Not screw the head onto your shaft too tight or you will end up with juice in your drip tip!

 

[JimCal]

Ya, i just figured that out last night. I bought a bottom coil clearomizor this weekend and screwed it on to my vision spinner. I went to take it off, but instead of it screwing off from the battery, the clearomizer came apart. E juice everywhere and a big 'ol mess. I was not a happy camper.

 

[greenpharmer]

Haha yeah, ive had issues charging and powering tanks because I accidently overtightened. Went to the shop they showed me how to pry out the pin and get it TN back working. I noticed my issues when the battery light would flash like it was dead when I pressed the button but it wasnt dead.