Hello guys.
[Issue referred to in the attached images]
Have just been messing around with my new dotmod petri 22mm rta.
The first few builds tasted great but experienced some leaking through the AFC.
I came to the conclusion that I was not tightening things down enough.
the 510 pin [A] could not fasten to the female teeth on the screw which is in the base of the build deck. [highlighted in photos]
To make this connection possible I had to loosen the pin in the bottom of the build deck .
I just wanted to know if this was a done thing and if anyone else had experienced this issue.
Thanks in advance
[Issue referred to in the attached images]
Have just been messing around with my new dotmod petri 22mm rta.
The first few builds tasted great but experienced some leaking through the AFC.
I came to the conclusion that I was not tightening things down enough.
the 510 pin [A] could not fasten to the female teeth on the screw which is in the base of the build deck. [highlighted in photos]
To make this connection possible I had to loosen the pin in the bottom of the build deck .
I just wanted to know if this was a done thing and if anyone else had experienced this issue.
Thanks in advance