dse 103/RN4081 Battery Disassembly?

[dougp925]

Does anyone know how to disassembly a dse-103/SE/solarflare/RN4081/peewee....etc battery? The LED cap pops off easy enough but I cant figure out how to remove the atomiser connector? I'm sure there is a post but I couldn't find it. I'm done with the intrnal pressure switches and I want to disassemble each battery and put in a small manual switch in place of the pressure switch. Can anyone please provide some insight. I'm very good with soldering and electronics.
Thanks in advance for any help
-Doug

 

[dougp925]

OK, I found the 801 battery disassembly post which tells you to gently heat the outer cylinder around the atomiser connector to soften the glue and then use an atomiser to pull out the connector. Does anyone know if this is the same for the DSE-103/SE/Peewee/solarflare2012/supermini....etc battery?
Thanks.
Doug

 

[Cellmeister]

OK, I found the 801 battery disassembly post which tells you to gently heat the outer cylinder around the atomiser connector to soften the glue and then use an atomiser to pull out the connector. Does anyone know if this is the same for the DSE-103/SE/Peewee/solarflare2012/supermini....etc battery?
Thanks.
Doug

Yes You Can Do That, The Battery Connector Is Glued & Pressed In. Just Go Slow & Take Your Time, Patients Is A Virtue On Some Of Them....

~Keep Vapin~!

 

[dougp925]

Thanx, worked like a charm....