So I finally found a filler mod that works for me. I settled on Fluval foam (similar to blue foam) and that's all I use. I cut it to fit fat on one end and narrow at the other, insert it narrow end in with tweezers into my 510 carts... and then I shove it all into the bottom, fill the cart with juice and use the tweezers to pull it out level to the edge again. With a few dunks for soaking.
When I refill I simply use the tweezers to shove it down to the bottom again, fill with juice, and then use the tweezers to sort of dunk the filler in and out a couple of times to get the juice soaked into the foam cells. Usually after I do this there is more room for adding a few more drops. Reposition the foam and I'm good to go.
No leaking, rarely flood the atty and lasts for a good while with plenty of juice. I'm a happy camper!
Lesson learned: Keep fiddling with what works and don't get discouraged! You'll find your vaping mojo!
When I refill I simply use the tweezers to shove it down to the bottom again, fill with juice, and then use the tweezers to sort of dunk the filler in and out a couple of times to get the juice soaked into the foam cells. Usually after I do this there is more room for adding a few more drops. Reposition the foam and I'm good to go.
No leaking, rarely flood the atty and lasts for a good while with plenty of juice. I'm a happy camper!
Lesson learned: Keep fiddling with what works and don't get discouraged! You'll find your vaping mojo!
