Ego-T 900 MAH Voltage issue

Status
Not open for further replies.

motelgrim

Senior Member
ECF Veteran
Apr 27, 2012
134
50
55
Florida
So I just received 20, 900mah ego-t batteries and right off the bat I felt that it wasn't pushing the usual voltage.
I metered it at 3.2,3.3 volts. Clearly too low for a fully charged battery. So I tested 3 more and the results were the same.
Anyone experience this? I will add that I've bought well over a hundred of these same batteries with no issues. The only difference is I bought these from a different vendor.

TIA
 

HughDaHand

Super Member
ECF Veteran
Verified Member
Nov 28, 2012
795
670
Swartz Creek, MI
From the joyetech website.

"The battery uses high technology, including 3.3V constant voltage output, protections against short circuit, protection against over-charging and discharging, and ensures continuous working of atomizers"
Joyetech eGo-T 900mAh Battery

Sounds like they are working to spec.
 

Kent C

ECF Guru
ECF Veteran
Verified Member
Jun 12, 2009
26,547
60,051
NW Ohio US
You don't mention it, But if you happen to have an eGo-t "upgrade" battery, then there are two modes you can access - one is the constant 3.3-3.4volts, and the other is an unregulated mode that is the same as any 3.7Volt battery - 4.1-4.2v off the charger, 3.6-3.7v for most of the charge... etc.

Looks like this with 'upgrade' clearly on the body of the battery:

Joyetech%20%20eGo%20T%20Upgrade%2018650%20Battery%20MOD%20Tube%20.jpg


If not, just get some 1.8ohm T3's... that will vape fine on most flavors.
 
Status
Not open for further replies.

Users who are viewing this thread