ego t atty question

[basshle]

recently purchased an ego t kit, (came with only 1 atomizer). Also purchased a couple of extra atomizers and liquid but from a different supplier. The spare atomizers do not make contact with the battery and therefore no vape. The spare atomizers connection is obviously recessed into the cone further than the kit atomizer. The cones bottom out on the battery before the battery makes contact at the center post of the atomizer. Is there any way to adjust the depth of the atomizer post in the cone? Or any other suggestions?

 

[carpedebass]

Interesting issue...are you sure you didn't order an atty for a 510T? How far does it seem the space is between the battery and the atty?

 

[juxt4p0z]

Welcome to ECF!

Sometimes the positive peg can get recessed to far in just about any atty setup (usually from the lookalike brands though). The best success I've had is to take a small tweezer and wiggle the peg back and forth a bit until it naturally comes out. Doesn't take much to make it work.

You can see videos of this on youtube, search for atomizer connection or something similar...there are lots of them out there.

 

[tj99959]

Common production problem, the center post is pushed to far in. I had a new Boge carto do the same thing this morning.
Just take a paper clip and wiggle the center post of the atty around.

 

[basshle]

the kit box says ego t, and the atomizers both have ego t printed on them. so I would assume that they are all authentic. but you never know. the depth difference is like 1/16th of an inch, very noticeable to the naked eye. so far I love the 1 working atomizer,but need backups. so I need to figure this out.

 

[arkador]

The paperclip trick should work. I have yet to experience this issue myself with over 50 cartos (all smoketek)

Sent from my Nexus S 4G using Tapatalk

 

[Iffy]

Don't forget that you can 'raise' both the batt and atty/carto center conductors. It doesn't take much, so be careful!

 

[basshle]

tried the paperclip trick. wiggled the center pin of the atty around and got it out some but nowhere near what is required.

 

[VTAK8K]

I just went through a similar problem where my eGo T battery would power some if my attys but not all. My spare batt would power them all without a problem. On the bad battery I stuck a pin right by the connector and wiggled it up just a bit and now it works perfect. Be careful not to overtighten your attys because you could push the connectors down.