ego-t cleaning question

[divinerebel]

Ive read alot about cleaning att's but i haven't heard about this.
while using fluxomizers i found vinegar cleaned very well , no gunk on the coil or wicks, it was amazing .
so i guess my question is can vinegar clean the ego -t att's with a water rinse afterward to remove the vinegar ?
any info or advice will be greatly appreciated

 

[divinerebel]

so i guess the vinigar idea isnt a good one?

 

[techtony]

Not sure, I've had mine for three weeks or so and haven't cleaned them yet but I use diferent atty's for different flavors.

 

[MitchellBeans]

Not sure, I've had mine for three weeks or so and haven't cleaned them yet but I use diferent atty's for different flavors.

I have had to 'clean' mine twice by blowing thru the battery end. The draw was getting really tight... this seemed to work. However I have never cleaned it otherwise.

 

[Sathane]

I blow out the atty from the battery end to get as much juice out as possible. I then take a QTip and clean off the battery contacts and in the atty itself. The Ego T spike allows you to get a qtip right beside it so that twisting the qtip actually runs it around the spike and soaks up any excess. I just dab at the bridge for the non-T attys.

If I need a more thorough cleaning (I never have but do it since I think it might make it last longer), I get some very hot water in a small locking lid type container and shake the hell out of it in there. I then blow out the excess water with a can of compressed air (for cleaning computers). To finish it off I either leave it out to dry, or, to expedite the process I set the attys on something so they won't move and let the hairdryer blow on it for 5-10mins.

Not sure if all this is necessary as I'm still very new but it works for me.