I recently bought a couple of itaste vv v3.0 batteries. One was in a kit with some iclear16 clearomizers. These have a non threaded skirt and fit perfectly to the device. Everything aligns just right. However, I also bought a couple of Kanger EVODs but they don't quite sit/thread right.
When they are screwed all the way down they connect and fire fine, but the they seem to sit at an angle. Specifically, when looking at the battery from the front (where the screen is) the bottom of the EVOD on the right hand side is touching the very top of the battery, but on the left side it is slightly above, leaving a gap of about 1mm.
I also have a vivi nova which has a threaded skirt like the EVOD, so a proper ego connector, and it also sits at this funny angle.
I was wondering if anyone else has seen this issue on an itaste VV as I'm wondering if it's a general problem with the model or just that I have received a device from a bad batch.
When they are screwed all the way down they connect and fire fine, but the they seem to sit at an angle. Specifically, when looking at the battery from the front (where the screen is) the bottom of the EVOD on the right hand side is touching the very top of the battery, but on the left side it is slightly above, leaving a gap of about 1mm.
I also have a vivi nova which has a threaded skirt like the EVOD, so a proper ego connector, and it also sits at this funny angle.
I was wondering if anyone else has seen this issue on an itaste VV as I'm wondering if it's a general problem with the model or just that I have received a device from a bad batch.
