EnerCig EC-NSX 22A 2600mAh 18650 Bench Test Results...a great battery, Sanyo UR18650NSX rewrap

These cells were donated for the purposes of testing by EnerCig in Germany. Thank you! To prevent any confusion with the eGo-type "batteries", I use the term "cell" here to refer to a single 18350, 18650, 26650, etc.

While the test results are hard data, the conclusions and recommendations I make based on these tests are only my personal opinion based on my criteria for setting a rating. Carefully research any cell you are considering using before purchasing.

Testing cells at their limits is dangerous and should never, ever, be attempted by anyone who has not thoroughly studied the dangers involved and how to minimize them.

If the cell has only one current rating number on it, or if it says "max discharging current" then I have to assume that the company is stating that the cell can be discharged at that current level in any way, including continuously.




Bottom Line
This is an great performing cell that I am rating at 22A/2500mAh. It is a rewrap of the Sanyo UR18650NSX which performs better than the Samsung 25R2 or 25R5. EnerCig is releasing the EC-NSX with a thicker, tougher wrap to help prevent damage. The wrap adds about 0.2mm to the diameter of the cell. This isn't much but it should be mentioned as mods that are already a tight fit for most cells might have trouble fitting these. The cells I tested were rated by EnerCig at the NSX's nominal capacity rating of 2600mAh but that is being changed to the 2500mAh rated capacity of the NSX.

The EnerCig cells are only available in Germany right now (www.intaste.de and www.dampfdorado.de) but they hope to have their cells available in the US soon.

The 18650 ratings table has been updated to include this cell.


Continuous-Current Test Results



Pulsed-Current Test Results



Comments

• At 10A continuous it reached 2340mAh. This is good performance for 2500mAh cell but a little low for a 2600mAh cell at 10A so I am rating this cell at 2500mAh.
• At 15A continuous the temperature rose to 66°C. This is way below the average temperature of a cell running at its continuous discharge rating (CDR).
• At 20A continuous the temperature rose to 72°C. This is a few degrees below the average temperature of a cell running at its CDR and an indication that we are near the cell's true rating.
• At 25A continuous the temperature rose to 83°C. This is a few degrees above the average temperature of a cell running at its CDR and an indication that we are near, but above, the cell's true rating.
• At 30A continuous the temperature rose to 92°C. This is a ridiculously high temperature and a strong sign that we're way above the cell's true rating.
• I am setting a CDR of 22A for this cell. Operating at that level would bring the temperature near to the average for a cell operating at its CDR. While operating any cell near its rated maximum current level causes damage to the cell, I would expect decent cycle life from this cell at 22A continuous.
• I have included pulsed discharges but I haven't set pass/fail standards for pulse testing yet. The discharges were done at 5sec on/30sec off, down to 2.5V. One chart shows the entire discharge at each level. The other chart is zoomed in to show the first 5 minutes to make it easier to see the voltage sag at different current levels.

To see how other cells have tested and how hard you can safely push them, check out these links:
List of Battery Tests | E-Cigarette Forum
18350/18500 Safety Grades and Pulse Performance Data | E-Cigarette Forum
18650 Battery Ratings -- Picking a Safe Battery to Vape With | E-Cigarette Forum
26650 Safety Grades and Pulse Performance Data | E-Cigarette Forum