I wanted it, too, but Wheezy says its shorting. So the Qorax version is apparently not the one to have 
Erlkonigin and Clone Comparison
- Thread starter jaxgator
- Start date
- th_trl_thread_readers 0
- Status
I wanted it, too, but Wheezy says its shorting. So the Qorax version is apparently not the one to have
Oh man, that's truly unfortunate.
Yea it's not working out for me. Will have to contact them and see what I can do. Maybe should've gotten the 26 dollar one instead. There's a short somewhere, either the 510 connection post is touching, post screws too long? Touching the bottom. Insulator is tore up.
I'm trying to fix it by eliminating what I can. But spent the last hour and nothing.
I'm trying to fix it by eliminating what I can. But spent the last hour and nothing.
Worst case, sell it to me and I'll rebuild it.
I like the atty a lot. Especially the writing on it. But it's the inside that is killing me. After looking at varieties of pics online this positive post does not look like others.
I think the positive pole is touching the inside in the middle of the atty. The derlin piece at top with the positive post doesn't seem snugged enough. It's loose, giving it free play to touch the sides of the wick channel. As you can see the post it doesn't have that "hump" like other clones.
I was very excited to try this atty out. Will see what happens. If this fits other that would be great.
Looks like the delrin insulator is shot and the screw is shorting on the base. Do you have a small o-ring?
Didn't take long for the Erl's to pop back up on Fasttech! Still no Nano's though.
Last edited:
Went back in and tried one more thing. Had a spare Kayfun insulator. Cut that piece in half so it fitted right in the connection point. Put a tiny o-ring and tightened down the positive pin. Everything was snugged. Wrapped another micro coil to 1.8ohms. On the Sig it went. Holding 1.8 just fine for a couple pulses. Heck lets wick and go. Filled up, still at 1.8. Vaped and found my inner peace for about 5 pulls. Vape gods must've felt my pain.
Crap..... Went down hill from there. Ohm started fluctating 1.8-4.0-3.2 and so on. But from those 5 pulls I can tell when this is working right (authentic???) it's a winner in my book. I got teased.
Crap..... Went down hill from there. Ohm started fluctating 1.8-4.0-3.2 and so on. But from those 5 pulls I can tell when this is working right (authentic???) it's a winner in my book. I got teased.
You might wish to look again.
$13.61 Mini RTA Rebuildable Tank Atomizer (3.0ml) - acrylic + stainless steel / 20.5mm dia. at FastTech - Worldwide Free ShippingAlready ordered mine.
You might wish to look again.
Already ordered mine.
Order placed! That popped up after the last time I checked. Can't wait to try it out!
Well after non-stop use since I got it my silver box FT erl clones tank finally got a crack as is leaking. I ordered a few replacements and was looking at a IBtank replacement but didnt want to take a chance of it not fitting. I think Ill order the erl nano from FT as I think it will fit on my istick even better and the 3ml juice capacity should be more than enough to get me through the day at work.
I just wonder if Ibtanked will eventually make a nano version tank?
I just wonder if Ibtanked will eventually make a nano version tank?
- Status
