EVDO leaking problem

Status
Not open for further replies.

nightcorona

New Member
Aug 10, 2015
1
0
59
I bought an EVDO basic kit and everything went well and taste was good, then suddenly it fell apart in my pocket and when I tried to get a replacement vaporizor it leaked no matter what I did. Big mess and gurgled alot. I noticed the new head looked a little different then the other but all seals seam to be there. I like this one so mad.........
What is wrong with this picture.
IMG_20150810_125110.jpg
 

suprtrkr

ECF Guru
ECF Veteran
Verified Member
Jun 22, 2014
10,410
14,675
Cowtown, USA. Where the West begins.
It does look like the seals are all there. I can't quite make out if the wick is sticking out of top of the atomizer/coil in the photo, but if it is, that looks normal. It might be loose or overtightened, both of which will cause leaks. "Just enough" is the way to go, snug and no more.m Or it could be a bad coil, too.
 

Grimwald

Vaping Master
ECF Veteran
Aug 12, 2012
3,666
5,425
Lawrence KS
There are different Evod tanks and different coil/heads. I can't quite make out what you've got there, but it looks more like a Protank mini...which also has different sizes and coils/heads.

If you try to put the single coil on a dual coil setup, or vice versa, you can get a situation that is not air tight. The small round gasket that slides on the coil/head chimney, must make a good seal with the bottom of the airflow tube. The picture looks like a single coil.
 
  • Like
Reactions: glointhedark
Status
Not open for further replies.

Users who are viewing this thread