Have had my evic for six months with no problems and yesterday it stopped firing my atomizer. No voltage to atomizer. I have switched out atomizer but no luck. The control head performs all other functions?? Any suggestions will be appreciated.
-
Need help from former MFS (MyFreedomSmokes) customers
Has any found a supplier or company that has tobacco e-juice like or very similar to MFS Turbosmog, Tall Paul, or Red Luck?
View thread
- Status
You only have one atomizer?
Know how to use a multimeter?
Could be several things. Sometimes the eVic can hang and will not fire properly on a Freshly fully charged battery.
This can usually be detected by holding the Firing button for about 8 seconds, release and quickly press again. If it starts to fire after a few cycles, this is the issue.
Another COMMON issue is the center post of an atomizer being pushed up and not contacting the eVic center pin. Very common issue and happens with regular batteries also.(Ego, Vision, etc)
Your atomizer coil could also have popped and is now dead.
Didn't give us much information to work with.
Know how to use a multimeter?
Could be several things. Sometimes the eVic can hang and will not fire properly on a Freshly fully charged battery.
This can usually be detected by holding the Firing button for about 8 seconds, release and quickly press again. If it starts to fire after a few cycles, this is the issue.
Another COMMON issue is the center post of an atomizer being pushed up and not contacting the eVic center pin. Very common issue and happens with regular batteries also.(Ego, Vision, etc)
Your atomizer coil could also have popped and is now dead.
Didn't give us much information to work with.
When you connect your atomizer, can you get a resistance reading from the control head?
Sent from my Sony Tablet S using Tapatalk 4 Beta
Screw atomizer onto eVic
Does eVic change to Reading Atomizer?
Does eVic recognize and Display Ohms?
Does eVic say No Atomizer Found?
Have you Read the Owners Manual?
Does eVic change to Reading Atomizer?
Does eVic recognize and Display Ohms?
Does eVic say No Atomizer Found?
Have you Read the Owners Manual?
If this is the expected result, then this doesn't sound too good. It might possibly mean that the boost circuit, or voltage regulator circuit is shot. You might want to contact joyetech and see what they say about it.
Sent from my Sony Tablet S using Tapatalk 4 Beta
Probably just a Firmware glitch. Before giving up, I'd do the Factory reset, then re-flash back to 1.3
Good chance it is salvageable.
If not interested in fixing, I have been looking for one to dissect in order to get more information to assist others. Mine seem to refuse to fail.
Good chance it is salvageable.
If not interested in fixing, I have been looking for one to dissect in order to get more information to assist others. Mine seem to refuse to fail.
- Status
Similar threads
