Favorite atty for your 5v GLV?

[Krisb]

I'm new to 5v vaping and just a bit unsatisfied with the attys I already had for 5v (I've only done 3.7 or vv). What is your favorite atty and at what ohm?

Sent from my ADR6300 using Tapatalk

 

[Krisb]

No one??

Sent from my ADR6300 using Tapatalk

 

[ZooKansas]

Same situation you're in Krisb, would like to hear some advice on this subject as well.

 

[Krisb]

Know I couldn't be the only one! 3ohm seems too high, 2.5 a pinch too low. A nice 2.8 would be nice, but darn hard to find!!

Sent from my ADR6300 using Tapatalk

 

[ZooKansas]

I'm going with the trustfire's that madvapes sells as my backup batts for now, as I have a gift certificate with them at the moment. Also, some standard resistance boge carto's, and a standard resistance 510 joye atty, between 2.0-2.5 to experiment with.

 

[Scottitude]

Don't do atties often enough to have any informed advice. I doubt if any atty is exactly as rated; I believe the ratings are more of an approximation or average. So your 2.8 could actually be 2.6 or 3.0 and your 3.0 could be 2.8 or 3.2.

A lot of people like IkenVape atties and when I do use atties, I prefer them as they do seem to be a little more consistent, quality and output wise.

 

[Bigmike228]

I have always used standard resistance 3.0-3.2ohm atties but check this link out. All atties work on the glv2 5v.
http://www.e-cigarette-forum.com/forum/greatlakesvapor/172046-glv-ohm-test-video.html

 

[keyzygirl]

I use 808 cartos so I cant help either.I think standard would be best though.

 

[AlmightyGod]

I use a 2.0ohm 306 on my 5v GLV.

I know that's a little crazy, but it works great for me!

 

[btngchck]

I'm new to 5v vaping and just a bit unsatisfied with the attys I already had for 5v (I've only done 3.7 or vv). What is your favorite atty and at what ohm?

Sent from my ADR6300 using Tapatalk

Krisb,

I have found that I like IKV's atties above everything else.

IKV LR/HV 2.5 510 with 5V is exactly where I like my perique
IKV 306 HV 3.5, but that's on a 6V is where I like my cafe mocha

I also like the IKV 801 mini's on a HV device, (but you can't use these with the GLV3 when attached to the feeder)

I have found that my atty/pv selection is more decided by the juice I am vaping as they are different with the different temps and devices.

I hope this helps, even just a little.......