So I have come up with the basic bottom plate for my dual coiled rda. The problem I am encountering now is finding something to use as a chamber on it... I had tried one of the tubes from Cajun injector needles I used to make a needle type carto tank, but they are just slightly too small to fit around the ss washer I used for my base. For my center post I used a broken 510 cigalike charger tip soldered to a brass screw then threaded to a few standoffs. SS screws for the negative posts soldered to the base. And some insulated putty to keep the + from grounding out to the - .
Don't worry, not planning on vaping it until I build v2, but definitely will need to invest in some pb-free solder soon.
Any suggestions on the tube portion?
Ended up being able to use a cheap paint cup I use for my DIY juices. Now to figure out an airflow solution and it will be ready to rebuild
Don't worry, not planning on vaping it until I build v2, but definitely will need to invest in some pb-free solder soon.
Any suggestions on the tube portion?
Ended up being able to use a cheap paint cup I use for my DIY juices. Now to figure out an airflow solution and it will be ready to rebuild
Last edited:
