Fogger v4++ build on a provari...

[jmercury1]

hi vapers, i just received a fogger v4++ SS, and i dont have a mech to use it on. so i was wondering if it was possible to use this on my provari and on my mvp2.0. also what would be the settings, gauge,wraps and on what size dril bit? thank you all for all your help and support, this community is the best.

 

[Tbev]

I recommend using cotton but you want a fairy small diameter coil, 2mm ecowool, or xc-116 is a great fit, just a size reference, this is due to the small amount of cotton needed in the channels.
I use 28ga 2x6 wraps nets 0.7 ohm.
For your provari 28ga with 8 wraps might get you by, but if you can id use 30 or 32ga,

Sent from my Transformer TF101 using Tapatalk

 

[Tbev]

Check out this thread,
http://www.e-cigarette-forum.com/forum/showthread.php?t=545703
Fogger V4!!

I'm planning on building one for my dad's regulated vamo so I ordered some 30 n 32ga as well but I haven't gotten around to it yet.

Sent from my Transformer TF101 using Tapatalk

 

[Tbev]

http://www.e-cigarette-forum.com/forum/showthread.php?t=545703
Fogger V4!!

Sent from my Transformer TF101 using Tapatalk

 

[jmercury1]

thank u Tbv, so much for your info, ill try your suggestion on my next build. i will also reread the fogger 4 + thread maybe i missed something. if anyone has any others have more suggestion please chime in. all is appreciated. keep on vaping vapors.

 

[Tbev]

I just received my 30/32ga wire and whipped up a new coil w xc -116 for my r91 and provari, works much better with 30 ga. Should be similar results with your situation.

Sent from my Transformer TF101 using Tapatalk