For the love of god....please help!
- Thread starter Kelly White
- Start date
- th_trl_thread_readers 0
- Status
Sounds like you forgot to "prime the cartomizer" to get liquid soaked into the filler.
Sent from my Atari 2600 using Tapatalk
Sent from my Atari 2600 using Tapatalk
You needed to prime the inside of the cartridge with juice first. Are you ready for me to show you how to do it?
That was not in the instructions!!! im not sure im gonna survive!!! IT WAS SO GROSE!!!!!
1) get a new cartridge
2) take the white cap off of it
3) observe the inside...a hole and some white cotton looking stuff (batting)...look at the outside of the carto, there are two small holes
4) plug up the little hole inside of the carto with a toothpick
5) drip a little juice inside the carto...not too much, you are going to do this several times.
6) shake the carto like a thermometer
7) drip more juice in
8)shake the carto like a thermometer
9) keep dripping and shaking until a little bit of juice starts coming out of the little holes
10) remove the toothpick
11) put the long black tool on the end of the carto
12) slide it into the tank but leave some room at the top to add juice
13) fill up your tank with juice and push the carto all of the way in to the top of the tank.
14) Remove the black tool
15) Add your drip tip
16) Attach the tank to the 'vari
17) Vape happy
Each time you change a carto you must prime it. you must only prime it once. You don't need to prime again until you start with a new carto.
Let me know how that goes....
2) take the white cap off of it
3) observe the inside...a hole and some white cotton looking stuff (batting)...look at the outside of the carto, there are two small holes
4) plug up the little hole inside of the carto with a toothpick
5) drip a little juice inside the carto...not too much, you are going to do this several times.
6) shake the carto like a thermometer
7) drip more juice in
8)shake the carto like a thermometer
9) keep dripping and shaking until a little bit of juice starts coming out of the little holes
10) remove the toothpick
11) put the long black tool on the end of the carto
12) slide it into the tank but leave some room at the top to add juice
13) fill up your tank with juice and push the carto all of the way in to the top of the tank.
14) Remove the black tool
15) Add your drip tip
16) Attach the tank to the 'vari
17) Vape happy
Each time you change a carto you must prime it. you must only prime it once. You don't need to prime again until you start with a new carto.
Let me know how that goes....
Last edited:
Just a thought. If you vaped that carto dry, throw it out. Once you burn the filler its no good. Start with a brand new one.
Sent from my Atari 2600 using Tapatalk
Sent from my Atari 2600 using Tapatalk
You can do it!!! I have faith...For the record I would have loved to see your faces...
...I am laughing but not at your expense mind you...it's just funny. =X
Im making a mess... is this supposed to happen? Im at the fill the tank thingy up
push the carto down a little bit...you have not left yourself enough room for the juice to go in....
you need a bit of a gap there...if you push it too far up there isn't enough room....
Everyone is laughing at my exspense so its ok... i have it filled but im to scared to try it.... staring at it with fear in my eyes
- Status
Similar threads
