Frustrations! Looking for the *best* system.

[RobFindlay]

As of now I have a 3.7v e-power which I totally love.

I've had a lot luck with Boge Cartomizers but that's about it. Every tank system i've tried FLüXOMIZER's the gotvapes Pumpcarts all either leak or don't wick right, at the moment I'm just drip tipping, but I seem to waste A LOT of juice because I keep flooding out my attys.
[h=1][/h]Has anyone found a good solid reliable, tank-like system for a 3.7 510 threaded device?

Thanks!!

 

[Tersur]

These are very reliable and afordable. Assuming you have the top and bottom grommet properly sealed. Carto Tank Mods

 

[donnah]

These are very reliable and afordable. Assuming you have the top and bottom grommet properly sealed. Carto Tank Mods

I was just going to say the same thing!! I love mine!

 

[RobFindlay]

These are very reliable and afordable. Assuming you have the top and bottom grommet properly sealed. Carto Tank Mods

That blows my mind, would the 1.7 ohm work on a 3.7 v device?

Also is there a youtube vid out there about how these things work? It's kind of blowing my mind.

And what do you mean about the grommets?

 

[Dieseler]

Yeah for the money these are good and no leaks
Acorn Tank Mods
like poster 2 he mentioned chibi those are for carto's and i use there acorn tanks for ce2s
Good luck and hope something works for you.

 

[Tersur]

Yes the 1.7 ohm are designed for 3.7v. and there is a filling vid on the Vendors home page for them.

 

[Tersur]

too slow donnah. all your post Lurks are mine!

I was just going to say the same thing!! I love mine!

 

[RobFindlay]

Yes the 1.7 ohm are designed for 3.7v. and there is a filling vid on the Vendors home page for them.

Might just have to give this one a try: LR Chibi Tank Mod (smoktech 1.7ohm)

Still don't see any videos though. Got a link?

 

[Tersur]

Chibi Tank Syringe Fill - YouTube

 

[Jeremy-WI]

Yes the 1.7 ohm are designed for 3.7v. and there is a filling vid on the Vendors home page for them.

I think the maH rating is much more important than the voltage on the batt, it is usually the determining factor on the safe discharge rate and affects the longevity of the battery.

Rob,

If your epower is 650 mah or bigger, the 1.7 ohm will work well. There is a small learning curve with using tanks. I usually fill my punched/slotted carto with juice and then put the tank on and fill it and then I take my needle and push it along the inside metal of the carto and watch the tank for the bubbles to escape. I can usually go through 10-14ml through a single boge 2 ohm carto with a tank before I need to toss the carto and that is with AVE's Bobas Bounty which is fairly dark 100% VG