Genisis LV and Box Kronos
- Thread starter Tai Pan
- Start date
- th_trl_thread_readers 0
- Status
Today is the 10th. At the 15th we close the Kronos Box.
If somebody forgot Genisis I just want to mention that we made some spares which can be ordered.
There will not be another run for Koronos and Genisis!
Uwe
If somebody forgot Genisis I just want to mention that we made some spares which can be ordered.
There will not be another run for Koronos and Genisis!
Uwe
Were the dimensions posted for the Kronos? I'd like to know the size of it... I'm very tempted to order one, but not if it's going to be too big.
Last edited:
Yes. How to see below.
Tai Pan
I have in my cart a 510 lv but it says is not avialable
If you order more set it into "Remarks" when you check out. Otherwise send me a mail: info@board-projekte.de
by Tai Pan in chronological order (might of missed something, not sure)
So the question is is the PCB design complete? If yes then box dimensions are known and going to production (next week?). As far as can tell though the Kronos box dimensions have not been revealed.
I added to my Kronos two Genisis LV,hope I still get them!!!
Thank you Tai Pan and thank you raidy for opportunity to get this great mod and genisis atty!!!
Thank you Tai Pan and thank you raidy for opportunity to get this great mod and genisis atty!!!
there was a video posted here ..but I can't find it...about rolling the mesh for the Genisis...if someone has it can you post it here...I forgot to bookmark it....
there was a video posted here ..but I can't find it...about rolling the mesh for the Genisis...if someone has it can you post it here...I forgot to bookmark it....
Genisis coil and meshroll preparing - YouTube
I'm going to order a Genesis atomizer as Tai Pan told me they have a couple extra ones. I'm just wondering what else do I need to order with that? I read kanthal, mesh, o-rings, mouthpieces, glass bottle???
Could someone please have a look at the invoice and tell me what parts are needed?
Could someone please have a look at the invoice and tell me what parts are needed?
The genisis lv will come with everything you need except the kanthal and ss mesh. I would order some of both, a set of o-rings as spares, a few spare bottles if available and a couple of spare mouthpieces.
How special is the mouthpiece for the Genisis LV? I mean, if I break the two I ordered, how easy will it be to find more? Should I order like 10 more of them just in case I can't replace them easily?
...and what about the bottle?
...and what about the bottle?
They are standard dse-701 mouthpieces if I am not mistaken and should be very easy to come by with a little googling
The bottle however may be a bit harder to get replacements for.
You can order the bottles direct from Germany.
http://www.holle-fachversand.de/art...49&bez=&artnr=&sid=p5ci9a9iis8e3uheuf3qcvqiu4
http://www.holle-fachversand.de/art...49&bez=&artnr=&sid=p5ci9a9iis8e3uheuf3qcvqiu4
Last edited:
keeping posted... i only ordered the mesh and wire with the Gen LV... and a Kronos box... i'll probably be able to pick up some more accessories (mouth piece/ rings etc) a little later... or not.
- Status
