GGTS problem

[hamdamann]

Hi so i got my GGTS with AVS today and it was working fine then i unscrewed the mouth piece and it unscrewed the atty with it and all the juice poured in the the bottom so i cleaned it out and reassembled it and filled it back up and now the atty wont get wet its like the juice in the tank isnt getting into the atty anyone have any clues

 

[Bimbo]

Did you close the collector tank screw first before removing the top cap? I had the same experience when I got mine. To make the atty wet, again close the CR and drag without firing it a few times. Open the CR a quarter of a turn and you are good to go.

When you screw it the mouthpiece, don't overdo it. It is enough that you get a small pressure when screwing it and it is ok. I recommend to check out the video of igetcha69 on youtube on assembling the AVS.

 

[rogerdugans]

Yeah, a bit of care is needed when removing the mouthpiece:
You can remove the TIP from the tip mounting ring ok, but if you want to check the tank level you'll need to remove (or at least back off- I remove it) the mouhtpiece mounting ring FIRST and then remove the AVS cap. Or else... yeah, you uscrew the atty.

First question: the collector tank is empty right? (tank under the AVS tank.)
Second: is the air Control Ring open?

If so, close it and inhale a couple of times- it should be a HARD pull.
Then open the control ring and try it again.

 

[hamdamann]

wow thanks guy i closed the air control ring and took a couple drags and now it seems to be working fine thanks for the help you guys are lifesavers