Go Go Fury Tank Leaks

Status
Not open for further replies.

binaryman

Senior Member
ECF Veteran
Feb 24, 2011
222
2
60
Eastern Shore, Maryland
All of my Fury tanks leak. I believe that I am somehow breaking them when I screw off the top to fill it will liquid (on first use), but I am not sure. I try avoid pouring the liquid down the metal tube, but it is possible that I do it. But generally after filling it 3/4 of the way, I begin noticing leakage. Usually within an hour the liquid has leaked out to 1/4 remaining. And I constantly have a paper towel on hand because the Go Go is soaked in liquid all the time.

I searched the threads and noticed only 1 person that had a similar problem, but I don't think they got resolution in the thread itself. I believe the thought was that the wick was soaking the juice up to fast and it was causing it to drip down the tube.

As i said, I must be doing something wrong.

Has anyone else had this problem and gotten around it ?
 

Topwater Elvis

Vaping Master
ECF Veteran
Dec 26, 2012
7,116
16,502
Texas
I haven't had any leaking issues like you describe from the fury tanks.
I don't really have any fix it tips other than; Maybe your juice is too thin, I use 50/50 vg/pg juices. Might try pushing up on the center tube from the base to make sure it's seated (remove mouth piece first), and pull the silicon cap under the mouth piece up slightly.
Look for tiny cracks in the plastic tank around the base.

I don't see how you could break them by removing the mouth piece, they should be just snug not tight.
I consider light seeping from condensation or rapid temp changes normal for most delivery devices, the fury tanks Ive owned all did that to some extent.
All my fury tanks have been smashed shattered cracked or otherwise destroyed, I much prefer the gocarts and M1 bcc over the fury tanks, might give them a try if you haven't.
 

binaryman

Senior Member
ECF Veteran
Feb 24, 2011
222
2
60
Eastern Shore, Maryland
Good point. I get my juice from MadVapes, and I don't have clue what the ratio of VG/PG is. It might be all PG for all I know.

Thanks for the response. On my next juice order I will make sure I do a 50/50.

I haven't had any leaking issues like you describe from the fury tanks.
I don't really have any fix it tips other than; Maybe your juice is too thin, I use 50/50 vg/pg juices. Might try pushing up on the center tube from the base to make sure it's seated (remove mouth piece first), and pull the silicon cap under the mouth piece up slightly.
Look for tiny cracks in the plastic tank around the base.

I don't see how you could break them by removing the mouth piece, they should be just snug not tight.
I consider light seeping from condensation or rapid temp changes normal for most delivery devices, the fury tanks Ive owned all did that to some extent.
All my fury tanks have been smashed shattered cracked or otherwise destroyed, I much prefer the gocarts and M1 bcc over the fury tanks, might give them a try if you haven't.
 
Status
Not open for further replies.

Users who are viewing this thread