Good 26g Mech Mod Build?

[MechanicalAndrew]

Hey guys,

Ive been searching for about a week now to find a half decent build for my Paragon mech mod. Im building in a velocity rda, however I only have 26g wire right now. Ive tried horizontal, vertical, twisted. Nothing works. It either has a super long ramp up time, or terrible vapor/flavor.

So what build can I do with 26g wire that ramps up quickly and has good vapor/flavor? Has to stay above 0.2 ohms.

 

[Vesuvius]

I just did a single parallel with 26g. Ramp up was instantaneous. A lot of vapor.

 

[Marc411]

A single running in between the posts is a pretty damn good vape.

Picture sucks but you'll get the idea. Get the coil high enough so you can see it through the air holes

 

[petrotech]

Dual coil...

6 wraps around 2.5 mm screw driver. Should be .4-.5 ohms.

It's what I run most of the time. I use 26 gauge 95% of the time.

 

[MechanicalAndrew]

I just did a single parallel with 26g. Ramp up was instantaneous. A lot of vapor.

Actually was my plan for tonight. 2.0mm 5 wrap single parallel.

 

[Vesuvius]

Actually was my plan for tonight. 2.0mm 5 wrap single parallel.

I went to low though. Ended up at .2ohm and about burned my lip on the drip tip which I am working on correcting now but parallels work good.