Got my provari. now have question

Status
Not open for further replies.

juicn

New Member
Dec 7, 2013
3
2
minnetonka,mn
Hi

so, I got my zombie provari. I got the kit with supplied kanger II. I have a kanger II on my svd and had no issues with it, changed coils more than a few times etc.

No I out the kanger II on the provari, and seems I like a lot of unrestricted air? At first, with the coil in tight, I was getting the E1 error. So I replaced the coil to the supplied 2.5 OHM and now I can tighten it up, but still lots of air flow.

I swapped out to my other kanger and its a nice restricted vape, not too much air. works nice and the way I like it.

SO, question is, what can I do to this other one to help it perform like the other kanger I have?

Ive had it apart, tightened it up and what not. and getting frustrated....:unsure:
 

xtwosm0kesx

Ultra Member
ECF Veteran
Verified Member
Jun 30, 2010
2,298
3,160
Face down in the gutter, USA
Not ideal but it should work. From an old thread (obv substitue Provari with 'ego/beauty-ring'):

Simplest fix is use the dental floss technique:

View attachment 246888

Wrap a piece of DF around 2 of the 3 holes on the 510 connector, arrange the floss legs in a way that they leave the 1 hole open and trail out in the airflow grooves if possible.

Hold the floss tails with your thumb (see pic) screw it onto the ego/beauty-ring till it seats, and snip the floss with fingernail clippers. Should tighten it up significantly.

*EDIT* Simplest NON-PERMANENT
 
Status
Not open for further replies.

Users who are viewing this thread