greets everyone

Status
Not open for further replies.
Just signed up to this site, have been lurking long enough. Lots of good info here and I would like to thank those that have helped by providing help to others. Been into vaping now for about two months and haven't looked back. This site has been my go to for those moments where I was lost. I started with ego and disposable clearomizers and now dripping with a Vamo V3 with an IGO-L.


Take care and see you all around...

-=v=-
 
thanks everyone for the responses. am really digging the vamo, even after getting the dreaded 9.9ohms reading on everything i put on it. after some trial and error(lots of them), i was able to pull it apart and resolder the wire onto the center pin. i will have to tear it down again because it looks like i did not put the display shield on properly. there is another thread that has a video of someone tearing down a v2 and the v3 is pretty much the same.

-=v=-
 

daleron

ECF Guru
ECF Veteran
Verified Member
  • Apr 16, 2013
    21,334
    379,257
    Arkansas, USA
    Just signed up to this site, have been lurking long enough. Lots of good info here and I would like to thank those that have helped by providing help to others. Been into vaping now for about two months and haven't looked back. This site has been my go to for those moments where I was lost. I started with ego and disposable clearomizers and now dripping with a Vamo V3 with an IGO-L.
    -=v=-
    Glad you signed on, stick around & enjoy the fun :)
     
    Status
    Not open for further replies.

    Users who are viewing this thread