Ok first - before I get further into this post, let me start by saying: I am in NO WAY responsible for damaged mods, atomizers, OR batteries from careless use. I am also NOT responsible for any injuries you may sustain by performing this build. I know, I punched a hole in my finger the other night while building this.
What you need for this build:
1x - 2mm Screw Driver
2x - 4-8in of 20AWG (gauge) wire (or if you're building a sleeper, double the wire length)
Some wick of your choosing
An atty with large enough holes to support that 20AWG wire and has a BEASTLY amount of AIRFLOW
1-2x - batteries with a 30AMP+ CDR (Continuous Discharge Rate)
A heavy duty mod (Variable OR Mechanical)
Now... GO!
This was more for the laughs - see what kind of builds you folks can get. On my build - ohmed out at .08 - .1. Good luck and have fun! I'll be posting a video shortly of my setup!
What you need for this build:
1x - 2mm Screw Driver
2x - 4-8in of 20AWG (gauge) wire (or if you're building a sleeper, double the wire length)
Some wick of your choosing
An atty with large enough holes to support that 20AWG wire and has a BEASTLY amount of AIRFLOW
1-2x - batteries with a 30AMP+ CDR (Continuous Discharge Rate)
A heavy duty mod (Variable OR Mechanical)
Now... GO!
This was more for the laughs - see what kind of builds you folks can get. On my build - ohmed out at .08 - .1. Good luck and have fun! I'll be posting a video shortly of my setup!