Ok so I was just watching one of rip trippers vids I currently run a dragon nano coming in at .6 ohms and it's a beast but I'm always looking for something more anyone know of anything harder hitting in a dual coil set-up info much appreciate
Sent from my HTCONE using Tapatalk
I've been working towards this utopia for a while now mah friend, so far it's kinda hard to tell. My hardest hitters (and I'm a hard hitting connoisseur) are:
-24ga dual super-nano-coil, wrapped 8 times and angled up slightly with the airflow right in front of the cannon.
-28ga dual nano/micro wrapped 6 times on 3/64" to keep the ohms low, and even though it's small, wicking through the center of the
coils still works best, tuck the tails under the coil, and then throw some lightly packed fluffy clouds under each, I keep them horizontal, because they get hot.
(both of the above are 1 second hitters, not the densest, but the fastest in your face
coils 
)
(for the "full bodied", warm and dense, longer than 1 second pull
coils, I like the following)
24ga or 28ga wrapped on a 5/64th drill bit, I usually wrap either 4-6 times, the less wraps the more intense. I like these too for a "mellower/dense vape", because they don't get dry easily, but they're still absolutely hellacious. The bigger the diameter coils, the less you have to worry about dry hits..
-Hope this helps, you won't be dissapointed with these, but makes sure you wrap the top two good, the right wicking is what makes super-nano coils work. Instead of the traditional wrap around technique, I actually tie a hitch know around them like this.
Here's what the 24ga supernano's look like naked (I tilt them slightly lower than this pic actually, keeps them wetter, this was an older pic):
And this is the vapor your get: it's almost too much, which is what I want
Hope this helps!
