HAVE YOU MET A PROBLEM WHEN CUTTING THE COIL?

[Everzon_Official]

Good day everyone.

Today we want to introduce --Hugsvape Coil Trimming Tool



What is it used for?

Last time, when I use Digiflavor drop rda to build the coil. After I have screwed the coil in the deck and cut the coil. It showed "short atomizer" with Aegis mod. Why did this happen? At last I found, there is a tiny part of coil dropped in the base. If I can know the length of the coil and cut before setting up in the base. This problem should be avoided.

After I use the coil trimming tool, this problem solved. Sometimes I am still not sure how long I should keep the coil when building. I try and try, and cut, and set up. No it's too long. So repeat again. Cut and set up. Now If I use this blue magic tool. I can build the coil very quickly.

Have you met the same problem with me? How you solve the problem at last?

Welcome to comment below.

Thanks for your time to watch this post.

Have a nice day.
Everzon Team

 

[stols001]

I suppose it is interesting and maybe something someone would want. I don't think I would because not only have I never "met" with that problem, I kind of think I might have a harder time than I do already affixing my screws to the posts, I like that extra wire to keep an eye on and snipping the end is probably one of the easier moments of my building experience.

With that said, I could see it being useful especially with dual coils but in that situation, maybe to try and get the legs as balanced as possible, by precutting (I'm never going to be a dual coiler either) but I think it's actually more useful for something like THAT reason than the one you suggested, although I guess it would work just fine for that purpose too.

Anna

 

[bigbob2322]

Iv'e seen these and think it's time to get one.

 

[Heartsdelight]

Iv'e seen these and think it's time to get one.

I got one & although it’s a copy of the Coily from the UK so it’s shunned lol. It works great for postless decks.