HCigar Aqua on a SVD
- Thread starter acbrown
- Start date
- th_trl_thread_readers 0
- Status
The only issue that I see is that you may tap the hole in the deck where you don't have a coil installed, try to use a silica bushing from a clearo to make it fit in, because now you are getting some airflow where is not supposed to...
Yes I have a piece of a toothpick in the air hole and in the other juice channels I have toothpicks and pacted with cotton.
I would like to get a dual coil build in it that will work on the SVD.
Also I am getting a metal taste, I cannot get good flavor.
I would like to get a dual coil build in it that will work on the SVD.
Also I am getting a metal taste, I cannot get good flavor.
dual coil with an svd might not work out to good in an aqua imo. the only way might be using 32g wire. as for a metal taste? this sounds like its just not wicking correctly.
Agree, to make the Aqua work with an SVD or VAMO on double coils you need a thin wire make 10 wraps of kanthal 32 for each coil, this will give you 2.4 ohms on each coil and a total of 1.2 ohms resistance.
For the metalic taste, what are you using? cotton or silica? I read that for silica 3 mm works fine on the Aqua, I guess that 2mm eckowool will work fine also... Cotton is more handy
For the metalic taste, what are you using? cotton or silica? I read that for silica 3 mm works fine on the Aqua, I guess that 2mm eckowool will work fine also... Cotton is more handy
Think I am just going to sale it and get a Aspire Nautilus.
Sent from my SCH-I535 using Tapatalk
Sent from my SCH-I535 using Tapatalk
I have an aqua already but if I had an aspire, I would swap you in a minute.
- Status
Similar threads
