Hello

Status
Not open for further replies.

braveminion

Senior Member
Jan 13, 2016
225
223
42
Hello and welcome!

I've been vaping and smoking for 3 years. Just quit the cigs and moved to dripping last week.

I'm not great with all these wire gauge things so hopefully someone else will come along to answer you. If not, a coil calculator may be able to answer your question.

I haven't tried the rda you are thinking off but I have bought five others. The fishbone is my favourite but the one I recommend for someone starting out would probably be the velocity. It is super easy to build on and very flavourful.

Good luck with your next step :)


Sent from my SM-G925F using Tapatalk
 

BrotherBob

ECF Guru
ECF Veteran
Dec 24, 2014
14,102
12,438
Sunnyvale,CA,USA
Welcome and glad you joined.
First thing you need to decide is whats more important, flavor or clouds. 1.5 ohms is in the flavor area with very decent clouds. .5 ohms more clouds with less flavor.
Could read: .
I like more flavor a adequate clouds so I'm at: 6.7w @ 2 ohms/32ga. 5 (single) wraps Magma deep well RDA.
I am also thinking about getting into rebuilding drip atomizers
Might like to read: 2015: The Art of the Drip - A Dripping Primer - Spinfuel eMagazine
I was thinking an IGO W to start
I have read good things about this dripper. Wish I had one.
what gauge Kanthal would i use for an Ohm range
See suprtrkr comments.
The lower the ohm build the higher the cost of vaping.
 
  • Like
Reactions: EBates
Status
Not open for further replies.

Users who are viewing this thread