Hellvape Rebirth RTA Leaking?

Status
Not open for further replies.

RaisedFist

Full Member
Jul 20, 2019
44
102
    Hey all, I just got my Rebirth rta today and I fill it up to the top and it pours out of the bottom airflow holes.
    I thin my wicks, make sure the wells aren't over stuffed, stuck to all the rules, but it still just leaks.
    I've done it 3 times now and it leaks on me every time!:grr:
    Is there something I'm doing wrong? Please help me!:(
    Regards,

    K
     
    Reactions: stols001

    greek mule

    Unresolved Status
    ECF Veteran
    Feb 2, 2018
    1,397
    2,463
    Athens,Greece
      Check that the O-rings are in place.
      Use dual coil build with inner diameter 3mm(this will give you the proper amount of cotton to put into the wick ports).

      Cotton tails must not be too long,they have to just sit gently onto the holes,but they must have enough volume to prevent leaking.Watch the coil build tutorial in the video.
       

      zoiDman

      My -0^10 = Nothing at All*
      Supporting Member
      ECF Veteran
    • Apr 16, 2010
      41,053
      1
      82,208
      So-Cal
        Thanks for all of that, I did actually know all of that, and I thought I had done everything right, but on watching the video again I realized that I was wicking it like the Geekvape Zeus X RTA, it needed a more stuffed juice well, that was my problem.
        Thank you for making me revisit and realize my problem, you rock!
        :thumbs:

        Another Good habit to get into with Any RTA is to Close the Airflow adjustment when you 1st Fill/Re-Fill.

        Then turn the RTA upside down a couple of times before Opening Up the Airflow again.
         
        Status
        Not open for further replies.

        Users who are viewing this thread

          ')