Help me identify this kayfun clone, need replacement screws.

[latexyankee]

Got this at a local B&M a few months ago and lost the flow control screw. I need to order some but cant tell which version I have. There is no hole on the bottom, just 3 on the side. Help me out please, posting pics.

 

[State O' Flux]

It's either a M2.5 X 0.45 or M3 X 0.5 set screw - these two sizes are the most common used in authentics and clones. You can get them at hobby shops, some electronics supplies... and hardware stores that carry a good selection of small fasteners. Also Grainger and Fastenal.

 

[retic1959]

Got this at a local B&M a few months ago and lost the flow control screw. I need to order some but cant tell which version I have. There is no hole on the bottom, just 3 on the side. Help me out please, posting pics.

That's a 3.1 clone , it should take the M3 X.5 set screw , you can get them here . M20213 - M3X5 Slotted Set Cone Point Stainless Steel A2 DIN553

 

[latexyankee]

Thanks guys